2020) Ultimate Strength of a Plate under Shearing Force(Structure)
نویسندگان
چکیده
منابع مشابه
ultimate flexural strength of plate girders under the effect of weld crack in flange toe
the plate girders are used in important structural systems. the earlier design of plate girders was restricted to their critical bukling capacity. experimental and theoretical studies show the plate girders with vertical stiffners can carry load over than their critical buckling loads and then in modern design codes is permitted to use post- buckling capacity of them. in this case the out- of- ...
متن کاملShearing Strength of Soils
b = a length L c = the cohesion intercept M L T Ip = the plasticity index P = a force M L T u = the pore fluid pressure ML T θ = an angle Angle μ1 = shear strength reduction factor related to time effects μ2 = shear strength reduction factor related to fissuring σ = the normal stress on a plane M L T τ = the shearing stress on a plane M L T φ = the angle of internal friction Angle ψ = an angle ...
متن کاملPrediction of ultimate strength of shale using artificial neural network
A rock failure criterion is very important for prediction of the ultimate strength in rock mechanics and geotechnics; it is determined for rock mechanics studies in mining, civil, and oil wellborn drilling operations. Also shales are among the most difficult to treat formations. Therefore, in this research work, using the artificial neural network (ANN), a model was built to predict the ultimat...
متن کاملEffect of location and orientation of two short dents on ultimate compressive strength of a thin square steel plate
Thin plates are subject to several imperfections (including dents) which reduce the ultimate strength of plates. In this work, nearness effect of two short dents of same size on the ultimate strength of a thin square steel plate is numerically investigated. Dents are modeled on the FE surface of the undented plate by varying the location and orientation of dents and the centre distance between ...
متن کاملUltimate tensile strength of tooth structures.
OBJECTIVE This study determined the ultimate tensile strength (UTS) of enamel (E), dentin (D) and dentin-enamel junction (DEJ) using the microtensile technique. It was hypothesized that the UTS of dental structures varies according to location and nature. METHODS Intact occlusal enamel surfaces from extracted human third molars were etched with 37% phosphoric acid and bonded with a one-bottle...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Architectural Institute of Japan
سال: 1961
ISSN: 0387-1185,2433-0027
DOI: 10.3130/aijsaxx.69.1.0_325