2.5v 900 MHz 0.13µm CMOS cascode low noise amplifier for wireless application
نویسندگان
چکیده
منابع مشابه
A 900-MHz CMOS Bandpass Amplifier for Wireless Receivers
This dissertation describes the design of a CMOS 900-MHz bandpass amplifier that is suitable for RF transceivers. The work employs the state-of-art inductive degeneration techniques to minimize the noise figure and explores the use of lossy spiral inductors in high frequency circuit to realize input matching networks on-chip. A Q-compensation circuit is included to achieve a 25-MHz 3-dB bandwid...
متن کاملA 2.4GHz Cascode CMOS Low Noise Amplifier
A cascode CMOS low noise amplifier (LNA) is presented along with the used design methodology and measurement results. The LNA works at 2.4 GHz with 14.5 dB voltage gain and 2.8 dB simulated noise figure (NF). Powered from a 1.8 V supply, the core measured current consumption is 2.76 mA. An output buffer was designed to match a 50 Ω load and its current consumption is 5.5 mA. The technology used...
متن کاملA Low-Noise, 900-MHz VCO in 0.6- m CMOS
This paper describes a low-noise, 900-MHz, voltagecontrolled oscillator (VCO) fabricated in a 0.6m CMOS technology. The VCO consists of four-stage fully differential delay cells performing full switching. It utilizes dual-delay path techniques to achieve high oscillation frequency and obtain a wide tuning range. The VCO operates at 750 MHz to 1.2 GHz, and the tuning range is as large as 50%. Th...
متن کاملA Low Noise Cascode Amplifier
A low noise amplifier has been designed using a 2SK117 N channel J-FET as the input device in a cascode [1] configuration. Noise measurements on this amplifier yield a low frequency noise current of 0.25 fA/Yfu and a voltage noise of less than 1.2 n V NHz in the 500 Hz to 50 kHz region. Bloyet et al. [2] suggest a figure of merit of the product of the noise voltage and current as being appropri...
متن کاملA variable gain wideband CMOS low-noise amplifier for 75 MHz-3 GHz wireless receivers
A wideband CMOS variable gain low noise amplifier suitable for multi-standard radio applications between 75 MHz and 3 GHz is presented. Wideband matching to 50 Ohm (single ended) is achieved using a common-drain feedback stage whereas variable gain is realized using a resistive attenuator. The circuit has been designed in a 65 nm CMOS process and achieves 22 dB maximum gain, 29 dB gain range, 3...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOSR journal of VLSI and Signal Processing
سال: 2013
ISSN: 2319-4197,2319-4200
DOI: 10.9790/4200-0160709