3D Coulomb balls: experiment and simulation
نویسندگان
چکیده
منابع مشابه
3D Coulomb balls: experiment and simulation
Spherically symmetric three-dimensional charged particle clusters are analyzed experimentally and theoretically. Based on accurate molecular dynamics simulations ground state configurations and energies with clusters for N ≤ 160 are presented which correct previous results of Hasse and Avilov [Phys. Rev. A 44, 4506 (1991)]. A complete table is given in the appendix. Further, the lowest metastab...
متن کاملCoulomb fission in multiply charged molecular clusters: Experiment and theory.
A series of three multiply charged molecular clusters, (C6H6)nz+ (benzene), (CH3CN)nz+ (acetonitrile), and (C4H8O)nz+ (tetrahydrofuran), where the charge z is either 3 or 4, have been studied for the purpose of identifying the patterns of behaviour close to the charge instability limit. Experiments show that on a time scale of ∼10-4 s, ions close to the limit undergo Coulomb fission where the o...
متن کاملFabrication of nanoscale Ga balls via a Coulomb explosion of microscale silica-covered Ga balls by TEM electron-beam irradiation
Nanoscale Ga particles down to 5 nm were fabricated by an explosion via an in situ electron-beam irradiation on microscale silica-covered Ga balls in a transmission electron microscope. The explosion is confirmed to be a Coulomb explosion because it occurs on the surface rather than in the whole body of the insulating silica-covered Ga micro-balls, and on the pure Ga nano-balls on the edge of c...
متن کاملLocal simulation algorithms for Coulomb interactions.
Long ranged electrostatic interactions are time consuming to calculate in molecular dynamics and Monte Carlo simulations. We introduce an algorithmic framework for simulating charged particles which modifies the dynamics so as to allow equilibration using a local Hamiltonian. The method introduces an auxiliary field with constrained dynamics so that the equilibrium distribution is determined by...
متن کامل3D-Simulation and Experiment of Gas Penetration Length in Gas-Assisted Injection Molding
Gas-assisted injection molding process is much complicated,the process parameters have multiplied. In this paper, a product with typical character of gas-assisted injection molded part is employed as the object of study. With the mould of gas-assisted injection molding and MPI/3D GAS in Moldflow software,the influence rule of the 6 important process parameters on gas penetration length in gas-a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2005
ISSN: 1742-6588,1742-6596
DOI: 10.1088/1742-6596/11/1/023