3D FEM Simulation of Water Vapor Jet Assisted Metal Cutting
نویسندگان
چکیده
منابع مشابه
3D FEM Simulation of Water Vapor Jet Assisted Metal Cutting
Water vapor jet assisted metal cutting is a pollution-free green cutting technique. This paper has developed a three-dimensional finite element model of water vapor jet assisted cutting in order to understand the influence of its cooling and lubricating effect on cutting process. The cooling effect of water vapor jet is modeled with a convective heat transfer coefficient. A window with the temp...
متن کاملDevelopment of a Water-Jet Assisted Underwater Laser Cutting Process
We present the development of a new underwater laser cutting process in which a water-jet has been used along with the laser beam to remove the molten material through kerf. The conventional underwater laser cutting usually utilizes a high pressure gas jet along with laser beam to create a dry condition in the cutting zone and also to eject out the molten material. This causes a lot of gas bubb...
متن کاملWater jet-assisted lipoplasty.
Water jet-assisted lipoplasty channels a thin, targeted, fan-shaped jet into adipose tissue to loosen tissue structure and release adipocytes. According to the authors, water jet-assisted lipoplasty facilitates preinfiltration of modified tumescent solution to create analgesia, resulting in painless or near painless lipoplasty. The authors contend that, with this method, patient safety has incr...
متن کاملnumerical simulation of abrasive water jet cutting process using the sph and ale methods
on account of some complexities such as fluid-structure interaction and extra-large deformation problems, complete simulation of abrasive water jet cutting process is very hard. the main goal of this paper is to overcome these difficulties through comprehensive simulation in ls-dyna commercial software. for this purpose the smoothed particle hydrodynamics (sph) and arbitrary lagrangian eulerian...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Open Mechanical Engineering Journal
سال: 2014
ISSN: 1874-155X
DOI: 10.2174/1874155x20140501007