3D Finite Element Analysis of a Single Asperity Tangential Elastic-plastic Deformation Characteristics
نویسندگان
چکیده
منابع مشابه
Finite element analysis of elastic-plastic solids under Vickers indentation: surface deformation
Finite element modeling has been used to study the development of surface deformation during indentation with a Vickers indenter. A wide range of materials with different elastic modulus and yield stresses are examined. Results show that in a pyramidal indentation process, for a perfectly plastic material, sinking-in during loading can change to pile-up in unloading. This phenomenon depends on ...
متن کاملFinite-element Formulations for Problems of Large Elastic-plastic Deformation
Abstract-An Eulerian finite element formulation is presented for problems of large elastic-plastic flow. The method is based on Hill’s variational principle for incremental deformations, and is ideally suited to isotropically hardening Prandtl-Reuss materials. Further, the formulation is given in a manner which allows any conventions finite element program, for “small strain” elastic-plastic an...
متن کاملElastic-plastic Deformation at Finite Strains
In some circumstances, elastic-plastic deformation occurs in which both components of strain are finite. Such situations fall outside the scope of classical plasticity theory which assumes either infinitesimal strains or plastic-rigid theory for large strains. The present theory modifies the kinematics to include finite elastic and plastic strain components. For situations requiring this genera...
متن کاملStabilized finite element formulation for elastic–plastic finite deformations
This paper presents a stabilized finite element formulation for nearly incompressible finite deformations in hyperelastic–plastic solids, such as metals. An updated Lagrangian finite element formulation is developed where mesh dependent terms are added to enhance the stability of the mixed finite element formulation. This formulation circumvents the restriction on the displacement and pressure ...
متن کاملA Self-Consistent Scheme for Elastic-Plastic Asperity Contact
In this paper, a generalized self-consistent scheme, or “three phase model”, is used to set up a micro-mechanics model for rough surface contact with randomly distributed asperities. The dimensionless average real pressure p is obtained as function of the ratio of the real contact area to the apparent contact area, 0 / A Ar . Both elastic and plastic materials are considered, and the influence ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Applied Sciences
سال: 2013
ISSN: 1812-5654
DOI: 10.3923/jas.2013.4688.4694