3D Video Simulation System Using GPS
نویسندگان
چکیده
منابع مشابه
GPS Signal Simulation using Open Source GPS Receiver Platform
Embedded GPS receivers have become commonplace with the proliferation of GPS navigation systems into all but the least expensive vehicle and cell phone lines. As more manufacturers embed low-cost GPS receivers into their products, the need for low-cost GPS signal simulators has also grown. Controlled virtual testing is vital in ensuring the expected system performance. NAVSYS developed a low co...
متن کاملHardware Co-simulation For Video Processing Using Xilinx System Generator
The use of rapid prototyping tools such as MATLABSimulink and Xilinx System Generator becomes increasingly important because of time-to-market constraints. This paper presents a methodology for implementing real-time DSP applications on a reconfigurable logic platform using Xilinx System Generator (XSG) for Matlab. The methodology aims to improve the design verfication efficiency for such compl...
متن کاملUsing 1D & 3D Simulation for Mechatronic System Design
Products and processes have become increasingly complex to meet demands on performance, reliability, and cost. As a result, simulation has become a key component to successfully designing and delivering these products to market. Mechatronics--also known as smart or cyber-physical systems—is a marriage of machine to sensors, actuators, and computing power to achieve the system goals which cannot...
متن کاملGPS-Aided Video Tracking
Tracking moving objects is both challenging and important for a large variety of applications. Different technologies based on the global positioning system (GPS) and video or radio data are used to obtain the trajectories of the observed objects. However, in some use cases, they fail to provide sufficiently accurate, complete and correct data at the same time. In this work we present an approa...
متن کاملIndoor GPS Metrology System with 3D Probe for Precision Applications
There is an increasing demand from industry for intelligent reverse engineering solutions. The requirement is to be able to perform reverse engineering, to create CAD models, or to compare prototypes with CAD models. A reverse engineering solution that can be used for 6 degrees of freedom pose measurement in a large area is desired. With this application in mind, we have developed a ‘3D Probe’ ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korea Institute of Information and Communication Engineering
سال: 2014
ISSN: 2234-4772
DOI: 10.6109/jkiice.2014.18.4.855