4-components Wind Tunnel Load Cell with Aerostatic Bearing Methods
نویسندگان
چکیده
منابع مشابه
Frictional Characteristics of a Small Aerostatic Linear Bearing
Frictional characteristics of a small aerostatic linear bearing are accurately evaluated by means of a method, in which the force acting on the moving part of the bearing is measured as the inertial force. An optical interferometer is newly developed to measure the Doppler shift frequency of the laser light reflected on the small moving part. From the measured time-varying Doppler shift frequen...
متن کاملDesign and Characterization of an Aerostatic Spherical Bearing
An aerostatic spherical bearing has been developed for parallel kinematic machines. The design is based on a ball and socket configuration and is preloaded by permanent magnets arranged about the socket. High pressure air is injected through three orifices into the cavity between the ball and socket to produce a low friction, high accuracy interface. Joint accuracy is measured using a coordinat...
متن کاملClosed-Loop Control Wind Tunnel Tests on an Adaptive Wind Turbine Blade for Load Reduction
Wind tunnel tests on a non-rotating, dynamically scaled wind turbine blade equipped with variable trailing edge geometry were carried out. The effectiveness of the system for active load reduction purposes, with the interaction between structural dynamics, aerodynamics and control was tested. The actuation of the adaptive trailing edge was based on a piezoelectric bender actuator. The full aero...
متن کاملDevelopment of Orifice-type Aerostatic Thrust Bearing for Precision Machine
Air bearings are used in precision machines and measurement equipments for recently years. Unlike conventional ball or roll bearings, there is no physical contact between the sliding surfaces and the moving surface. Therefore, the structure with air bearings can glide smoothly on the other surface to avoid generating the small particles from the friction contact and also minimize the control ef...
متن کاملBearing Testing Machine with Rotating Load Vector
A concept of new test stand for investigating fatigue strength of plain bearing surface layer has been presented in the paper. The machine with rotating load vector was designed, built and experimentally verified in tribological laboratory of the Technical University of Gdańsk. The machine of such a principle of slide bearing surface layer load generation is, according to ISO 7905 standard, a b...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Wind Engineering
سال: 2016
ISSN: 1349-340X,1349-3507
DOI: 10.5359/jwe.41.48