4874563 Process for preparing tows from composite fiber blends
نویسندگان
چکیده
منابع مشابه
Characterization of Biodegradable Composite Films Prepared from Blends of Poly(Vinyl Alcohol), Cornstarch, and Lignocellulosic Fiber
Several composite blends of poly(vinyl alcohol) (PVA) and lignocellulosic fibers were prepared and characterized. Cohesive and flexible cast films were obtained by blending lignocellulosic fibers derived from orange waste and PVA with or without cornstarch. Films were evaluated for their thermal stability, water permeability and biodegradation properties. Thermogravimetric analysis (TGA) indica...
متن کاملFiber- Reinforced Composite for Orthodontic Anchorage Technique
Introduction: In orthodontic treatment, adequate anchorage is necessary to move the intended teeth. In some cases, just anterior teeth are malaligned, while posterior occlusion is acceptable. Therefore, the posterior teeth could be integrated by fiber-reinforced composite (FRC) to provide a rigid anchorage. This method proved advantageous since brackets are bonded just to anter...
متن کاملEffect of tool surface topography on friction with carbon fibre tows for composite fabric forming
http://dx.doi.org/10.1016/j.compositesa.2016.10.017 1359-835X/ 2016 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0/). ⇑ Corresponding author presently at: School of Engineering, University of Glasgow, G12 8QQ, UK. E-mail address: [email protected] (D.M. Mulvihill). Daniel M. Mulvihill ⇑, Mic...
متن کاملFiber Bundle Models for Composite Materials
In this paper we will outline the advantages of using fiber bundles in modeling disordered materials. We will present the main aspects of classical fiber bundle models (FBMs) and highlight their ability to capture some essential aspects of composite materials. We then present some extensions of the classical FBM, modifying the way of interaction of fibers, failure law, deformation state and con...
متن کاملFriction of carbon fibre tows
The fundamental frictional behaviour of carbon fibre tows relevant to composite fabric forming is explored. Tow-on-tool and tow-on-tow contact are considered. For tow-on-tool contact, an experiment is devised to simultaneously observe the true filament contact length and measure the friction force over a range of normal loads. Filament contact length is not constant, as would be given from an i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Carbon
سال: 1990
ISSN: 0008-6223
DOI: 10.1016/0008-6223(90)90036-x