6<i>H</i>-[1,2,5]Thiadiazolo[3,4-<i>e</i>]thieno[3,2-<i>b</i>]indole-flanked <i>para</i>-azaquinodimethane based aromatic-quinoidal polymer semiconductors with high molecular weights synthesized <i>via</i> direct arylation polycondensation
نویسندگان
چکیده
The 6 H -[1,2,5]thiadiazolo[3,4- e ]thieno[3,2- b ]indole-flanked para -azaquinodimethane ( p -AQM)-based polymer semiconductors PQ-1 and PQ-2 are rationally designed through a ?-extended aromatic-quinoidal design strategy.
منابع مشابه
Effects of the Terminal Structure, Purity, and Molecular Weight of an Amorphous Conjugated Polymer on Its Photovoltaic Characteristics.
The photovoltaic characteristics of an amorphous polymer containing EDOT and fluorene units were investigated. In particular, the effects of the terminal structure, residual amount of Pd, and molecular weight were systematically investigated. Direct arylation polycondensation of EDOT followed by an established purification method readily afforded polymers with different terminal structures, Pd ...
متن کاملTMEDA-assisted effective direct ortho arylation of electron-deficient N-heteroarenes with aromatic Grignard reagents.
In the addition of TMEDA in toluene, aryl Grignards could effectively and site-specifically ortho-arylate electron-deficient heteroarenes under mild conditions. This endeavor successfully changed the old low-yielding reaction, aryl Grignard addition to N-heteroarenes, into an efficient procedure for heterobiaryls. The combination of the inexpensive aryl Grignards, TMEDA, the cost-free air, no u...
متن کاملGold-catalyzed direct arylation.
Biaryls (two directly connected aromatic rings, Ar(1)-Ar(2)) are common motifs in pharmaceuticals, agrochemicals, and organic materials. Current methods for establishing the Ar(1)-Ar(2) bond are dominated by the cross-coupling of aryl halides (Ar(1)-X) with aryl metallics (Ar(2)-M). We report that, in the presence of 1 to 2 mole percent of a gold catalyst and a mild oxidant, a wide range of are...
متن کاملHighly monodisperse conjugated polymer particles synthesized with drop-based microfluidics.
A facile method for preparing highly monodisperse, sub-micrometre conjugated polymer particles is reported. The particles are prepared through emulsification of a conjugated polymer solution on a microfluidic chip followed by solvent evaporation. The particle size is tuned between 150 nm to 2 μm, by controlling the polymer concentration.
متن کاملEffect of Polymer Grade and Plasticizer Molecular Weights on Viscoelastic Behavior of Coating Solutions
Film coating solutions containing different grades of HPMC (E5, E15 and E50) with and without polyethylene glycol (with various molecular weights) were examined by an oscillatory method, using Haake CV 100 rheometer. Fundamental rheological parameters (?, G? and G² ) were measured over the frequency range from 0.04 to 2 Hz. The variation with frequency of the loss tangent (a ratio of viscous to...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials advances
سال: 2023
ISSN: ['2633-5409']
DOI: https://doi.org/10.1039/d3ma00037k