A 1.9-GHz Triple-Mode Class-E Power Amplifier for a Polar Transmitter
نویسندگان
چکیده
منابع مشابه
A Class E Power Amplifier with Low Voltage Stress
A new output structure for class E power amplifier (PA) is proposed in this paper. A series LC resonator circuit, tuned near the second harmonic of the operating frequency is added to the output circuit. This resonator causes low impedance at the second harmonic. The output circuit is designed to shape the switch voltage of the class E amplifier and lower the voltage stress of the transistor. T...
متن کاملa class e power amplifier with low voltage stress
a new output structure for class e power amplifier (pa) is proposed in this paper. a series lc resonator circuit, tuned near the second harmonic of the operating frequency is added to the output circuit. this resonator causes low impedance at the second harmonic. the output circuit is designed to shape the switch voltage of the class e amplifier and lower the voltage stress of the transistor. t...
متن کاملA 13W Current Mode Class D High Efficiency 1 GHz Power Amplifier
13 watt Current Mode Class-D (CMCD) with 60% efficiency is presented. This amplifier is the highest power switch mode microwave power amplifier reported to date. The CMCD architecture is an improvement over the Voltage Mode Class-D in that the parasitic reactance in the active device can be absorbed into the tank circuit resulting in a zero voltage switching condition.
متن کاملA 0.1-5.0 GHz Reconfigurable Transmitter With Dual-Mode Power Amplifier and Digitally-Assisted Self-Calibration for Private Network Communications
A 0.15.0 GHz 65 nm CMOS recongurable transmitter for private network wireless communications is presented. The transmitter integrates a 0.11.5 GHz high-efciency dual-mode power amplier to support low-cost narrowband applications and a 0.455.0 GHz efciency-optimized pre-power amplier to support high-performance wideband applications. A wideband PLL frequency synthesizer, DACs with recon...
متن کاملA 2.45 GHz 30dBm differential 0.18 μm CMOS class-E power amplifier with 42% PAE
This paper presents a 30dBm (1W) class-E power amplifier projected in a standard 0.18-μm CMOS technology. The power amplifier (PA) consists in two differentials stages. The main stage employs a cascode class-E RF power amplifier with a self-biasing circuit. The driver stage uses the technique of Injection-Locking to substantially reduce the input power signal, maintaining a high gain. At 2.45 G...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Microwave and Wireless Components Letters
سال: 2007
ISSN: 1531-1309
DOI: 10.1109/lmwc.2006.890345