A 75 GHz 13.92 dBm InP DHBT cascode power amplifier
نویسندگان
چکیده
منابع مشابه
Millimeterwave INP DHBT power amplifier based on poweroptimized cascode configuration
This letter describes the use of a power-optimized cascode configuration for obtaining maximum output power at millimeter-wave (mm-wave) frequencies for a two-way combined power amplifier (PA). The PA has been fabricated in a high-speed InP double heterojunction bipolar transistor technology and has a total active emitter area of 68.4 lm2. The experimental results demonstrate a small signal gai...
متن کاملA 125-170 GHz wideband high-power amplifier using 0.5-µm InP DHBT
In this paper, a D-band power amplifier (PA) based on 0.5-μm InP DHBT is presented. Wilkinson combiners with broadband stepped-impedance matching are used, and the eight-way PA is designed for wideband power performance. As input power is fixed at 3 dBm, the PA exhibits a saturated output power of 16.8 dBm and 7.9% PAE at 150 GHz with >45-GHz 3-dB power bandwidth from 125 GHz to 170 GHz. Meanwh...
متن کاملA 2.4-GHz 0.18- m CMOS Self-Biased Cascode Power Amplifier
A two-stage self-biased cascode power amplifier in 0.18m CMOS process for Class-1 Bluetooth application is presented. The power amplifier provides 23-dBm output power with a power-added efficiency (PAE) of 42% at 2.4 GHz. It has a small signal gain of 38 dB and a large signal gain of 31 dB at saturation. This is the highest gain reported for a two-stage design in CMOS at the 0.8–2.4-GHz frequen...
متن کامل140-220 GHz Imaging Front-end Based on 250 nm InP/InGaAs/InP DHBT Process
This paper presents a pre-amplified detector receiver based on a 250 nm InP/InGaAs/InP double heterojunction bipolar transistor (DHBT) process available from the Teledyne scientific. The front end consists of a double slot antenna followed by a five stage low noise amplifier and a detector, all integrated onto the same circuit. Results of measured responsivity and noise are presented. The recei...
متن کاملA CMOS Class-E Cascode Power Amplifier for GSM Application
The design of A 2.4-GHz CMOS Class E cascode power amplifier (PA) for GSM applications in TSMC 0.18-μm CMOS technology present in this paper. Proposed Class E cascode PA topology is a single-stage topology in order to minimize the device stress problem. A parallel capacitor is connected across the transistors for efficiency enrichment also for dominating the effect of parasitic capacitances at ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JOURNAL OF INFRARED AND MILLIMETER WAVES
سال: 2012
ISSN: 1001-9014
DOI: 10.3724/sp.j.1010.2012.00294