A bulk silicon SOI process for active intevated sensor
نویسندگان
چکیده
منابع مشابه
Electronics and Sensor Study with the OKI SOI process
While the SOI (Silicon-On-Insulator) device concept is very old, commercialization of the technology is relatively new and growing rapidly in high-speed processor and lowpower applications. Furthermore, features such as latch-up immunity, radiation hardness and high-temperature operation are very attractive in high energy and space applications. Once high-quality bonded SOI wafers became availa...
متن کاملExperimental Comparison of RF Power LDMOSFETs on Thin-Film SOI and Bulk Silicon
We have simultaneously fabricated RF power LDMOSFETs on thin-film SOI and bulk silicon wafers. This work compares their DC current–voltage ( – ), capacitance–voltage ( – ), -parameter, and 1.9-GHz load-pull characteristics and explains differences between them. The SOI LDMOSFET performance is shown to be largely similar to the performance of an equivalent bulk silicon LDMOSFET, but there are im...
متن کاملPerformance/Complexity Space Exploration : Bulk vs. SOI
Performance and complexity are considered here as two orthogonal axes. Performance metrics are recalled. Then different complexity metrics and scales are proposed. Different definitions of complexity are used depending on the considered level of abstraction. Finally, SOI and bulk CMOS technologies are compared in this space.
متن کاملAmorphous Silicon Active Pixel Sensor Readout Circuit for Digital Imaging
The most widely used architecture in large-area amorphous silicon (a-Si) flat panel imagers is a passive pixel sensor (PPS), which consists of a detector and a readout switch. While the PPS has the advantage of being compact and amenable toward high-resolution imaging, reading small PPS output signals requires external column charge amplifiers that produce additional noise and reduce the minimu...
متن کاملSOI RF Switch for Wireless Sensor Network
The objective of this research was to design a 0-5 GHz RF SOI switch, with 0.18um power Jazz SOI technology by using Cadence software, for health care applications. This paper introduces the design of a RF switch implemented in shunt-series topology. An insertion loss of 0.906 dB and an isolation of 30.95 dB were obtained at 5 GHz. The switch also achieved a third order distortion of 53.05 dBm ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sensors and Actuators A: Physical
سال: 1990
ISSN: 0924-4247
DOI: 10.1016/0924-4247(90)80016-x