A Ceramic-Anode Supported Low Temperature Solid Oxide Fuel Cell
نویسندگان
چکیده
منابع مشابه
Three-dimensional modeling of transport phenomena in a planar anode-supported solid oxide fuel cell
In this article three dimensional modeling of a planar solid oxide fuel cell (SOFC) was investigated. The main objective was to attain the optimized cell operation. SOFC operation simulation involves a large number of parameters, complicated equations, (mostly partial differential equations), and a sophisticated simulation technique; hence, a finite element method (FEM) multiphysics approach ...
متن کاملCeramic - Based Anode for Solid - Oxide Fuel Cell Utilizes
490 MRS BULLETIN/JULY 2002 nated by intergranular fracture, while in AJM it was in a manner resembling ductile behavior. Improved surface finishing by AJM resulted in a 15% improvement in flexural strength, compared with both ground and ground-plus-lapped samples. The researchers concluded that a higher compressive residual stress observed on the AJM-processed surface, combined with the smoothe...
متن کاملNanostructuring Platinum Nanoparticles on Ni/Ce0.8Gd0.2O2-δ Anode for Low Temperature Solid Oxide Fuel Cell via Single-step Infiltration: A Case Study
With the aim of promoting the Ni/Ce0.8Gd0.2O2-δ (Ni/GDC20) cermet anodic performance of low temperature solid oxide fuel cell (LT-SOFC) [1], nanostructuring platinum nanoparticles on NiO/GDC composite was done by single-step wet-infiltration of hexachloroplatinic acid hexahydrate (H2PtCl6.6H2O) precursor on NiO/GDC20 composite. The anodic polarization resistance was measured using symmetr...
متن کاملOperation of Ni-YSZ Anode Supported Solid Oxide Fuel Cell on Different Simulated Syngases
Ni-YSZ anode supported solid oxide fuel cells (ASCs) were tested under various simulated syngas. There was no voltage degradation of the cell operated on 41%H2-7%CH4-6%CO-11%CO2-35%H2O fuel condition for nearly 450 hours. However, the high vapor content reduced the open circuit voltage (OCV) and discharge voltage. The cells run steadily with most dry syngas until the simulated reforming tempera...
متن کاملChemical precipitation and characterization of multicomponent Perovskite Oxide nanoparticles – possible cathode materials for low temperature solid Oxide fuel cell
A set of multicomponent perovskite oxide nanoparticles based on La1-xSrxCo1-yFeyO3-δ(LSCF) were prepared by a simple chemical precipitation method for application in low temperature solid oxide fuel cells (LT-SOFC) as cathode materials. The precursor materials used in this synthesis were lanthanum nitrate hexahydrate [La(NO3)<su...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Electrochemical and Solid-State Letters
سال: 2012
ISSN: 1099-0062
DOI: 10.1149/2.019206esl