A color flat panel using matrix drive and deflection system.
نویسندگان
چکیده
منابع مشابه
In vivo dose verification using using an amorphous silicon flat panel-type imager (a-Si EPIDs)
Introduction: Electronic portal imaging devices (EPIDs) could be used to dose verification of radiotherapy treatment plans. In vivo dose verification is performed to reduce differences found between dose delivered to the patient and the prescribed dose. The aim of this study was to perform a fast and efficient technique for the verification of delivered dose to the patient usin...
متن کاملA-Si FLAT PANEL
Flat Panel Illustration In 2000, a large array A-Si flat panel EPID detector was installed (AL-7) on one of the PRIMUS accelerator at UCSF to allow for a comparison of performance. During the development period of MVCBCT, the introduction in 2004 of a new flat panel (AG-9) better optimized for high energy photons showed a several fold increase in sensitivity, allowing the routine acquisition of...
متن کاملFocal spot measurements using a digital flat panel detector.
Focal spot size is one of the crucial factors that affect the image quality of any x-ray imaging system. It is, therefore, important to measure the focal spot size accurately. In the past, pinhole and slit measurements of x-ray focal spots were obtained using direct exposure film. At present, digital detectors are replacing film in medical imaging so that, although focal spot measurements can b...
متن کاملEvaluation of the quality of CT-like images obtained using a commercial flat panel detector system
PURPOSE The development of flat panel detector technology has resulted in renewed interest in the possibility of generating CT-like images from rotational angiographic acquisitions. At least two commercial products now use cone beam reconstruction software in conjunction with flat panel detectors to produce such images. The purpose of the work presented here is to report on image quality obtain...
متن کاملA Small Proposal for the Panel Inner Curvature for Flat-Surface Color Tubes
Regarding doming of AK mask, many investigations have been made so far. The mechanical design looks almost at the limit. Curvature design of the mask is a key point. The subject is discussed from the panel curvature point of view and a new panel curvature function that is advantageous for mask design is proposed
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of the Institute of Television Engineers of Japan
سال: 1986
ISSN: 0386-6831,1884-9652
DOI: 10.3169/itej1978.40.1024