A comparison of the different multiple response optimization techniques for turning operation of AISI O1 tool steel
نویسندگان
چکیده
منابع مشابه
comparison of the amount of debris extruded apically in two rotary techniques: flexmaster and m2
چکیده ندارد.
15 صفحه اولsimultaneous optimization of machining parameters and tool geometry specifications in turning operation of aisi1045 steel
machining operation is one of the most applicable processes for the manufacturing of industrial parts. usually, the quality of finished part in turning operation is measured in terms of surface roughness. in turn, surface quality is determined by machining parameters and tool geometry specifications. the main objective of this study is to model and optimize machining parameters and tool geometr...
متن کاملOptimization of Surface Roughness of Aisi 304 Austenitic Stainless Steel in Dry Turning Operation Using Taguchi Design Method
The present work is concentrated with the dry turning of AISI 304 Austenitic Stainless Steel (ASS). This paper presents the influence of cutting parameters like cutting speed, feed rate and depth of cut on the surface roughness of austenitic stainless steel during dry turning. A plan of experiments based on Taguchi’s technique has been used to acquire the data. An orthogonal array, the signal t...
متن کاملSurface integrity predictions and optimisation of machining conditions in the turning of AISI H13 tool steel
Surface integrity (SI) plays a very important role in functional performance. It is dependent on a large number of machining parameters. The major concern of industry is to know which combination of machining parameters provides the best SI of machined components. Traditionally, surface roughness is considered to be the principal parameter to assess the SI of a machined part. However, residual ...
متن کاملDesign optimization of cutting parameters for turning of AISI 304 austenitic stainless steel using Taguchi method
In the present work Taguchi method is used to optimize cutting parameters during dry turning of AISI 304 austenitic stainless steel with AlTiCrN coated tool. The coating was deposited on fine-grained K-grade (ISO K-20) cemented carbide cutting insert using physical vapor deposition (PVD) technique. The turning parameters evaluated are cutting speed of 200 and 260 m/min, feed rate of 0.20 and 0....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Engineering Research
سال: 2014
ISSN: 2307-1877,2307-1885
DOI: 10.7603/s40632-014-0030-z