A Diesel Engine Model for Dynamic Drive Cycle Simulations
نویسندگان
چکیده
منابع مشابه
A Diesel Engine Model for Dynamic Drive Cycle Simulations
The development and implementation of a diesel engine combustion system simulation model is described. The model is a crank angle based combustion model, which uses the conditions in the intake and exhaust manifolds together with the fuel injection signal from the engine control unit to estimate the in-cylinder pressure throughout a complete combustion cycle. The model is implemented in Matlab....
متن کاملA dynamic PCCI combustion model for Diesel engine control design
Subject of this work is a dynamic simulation model for PCCI combustion that can be used in closed-loop control development. A detailed multi-zone chemistry model for the high-pressure part of the engine cycle is extended by a mean value model accounting for the gas exchange losses. The resulting model is capable of describing PCCI combustion with stationary exactness. It is at the same time ver...
متن کاملInvestigation of Dual Fuel Diesel Engine With Particular Reference to Engine Cycle Model
In order to use gaseous fuels in Diesel Engines, Dual-Fuel Diesel Engine (D. F. D. E) the pilot injection approach is chosen. To predict its performance, an engine cycle model, based on limited-pressure Diesel cycle, is constructed. The model predicts D. F. D. E performance with LPG, and CNG gases. Comparing with pure Diesel engine, by increasing gas proportion in dual-fuel, indicated power and...
متن کاملAssessment of Atomization Models for Diesel Engine Simulations
Liquid fuel injection and atomization have a significant influence on the combustion and emission characteristics of diesel engines. Using x-ray radiography, it is possible to obtain quantitative and time-resolved data in the primary breakup region close to the injector nozzle. However, most previous studies on model validations have employed optical measurements that are not applicable in this...
متن کاملA Full-Cycle 3 Dimensional Numerical Simulation of a Direct Injection Diesel Engine
In the present work, multidimensional modeling of open-cycle process of OM355 engine was developed. Calculations for computational mesh were carried out. The results of the model were validated by experimentally measured in-cylinder pressure and the good agreement between calculations and measurements approved the trustworthy of numerical code. Results included pressure, temperature, emissi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IFAC Proceedings Volumes
سال: 2011
ISSN: 1474-6670
DOI: 10.3182/20110828-6-it-1002.03541