A dynamic instability of small planing craft at high speed turning
نویسندگان
چکیده
منابع مشابه
Performance Analysis and Prediction of High Speed Planing Craft
A comprehensive and critical review of literature pertaining to the study of planing craft is given within this work. This study includes monohull design, analysis and performance prediction for flat water; many features of the planing characteristics, including dynamic stability, the use of stepped hullforms, re-entrant transoms and flow characteristics are detailed. Work on the rough water se...
متن کاملMachinability Investigation of Inconel 657 in High-speed Turning
A high strength nickel chromium alloy (50Cr-50Ni-Nb alloy), commonly referred to as IN-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. The purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of Inconel 657. The considered parameters...
متن کاملMachinability Investigation of Inconel 657 in High-speed Turning
A high strength nickel chromium alloy (50Cr-50Ni-Nb alloy), commonly referred to as IN-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. The purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of Inconel 657. The considered parameters...
متن کاملDynamic crack tip equation of motion: high-speed oscillatory instability.
A dynamic crack tip equation of motion is proposed based on the autonomy of the near-tip nonlinear zone of scale l(nl), symmetry principles, causality, and scaling arguments. Causality implies that the asymptotic linear-elastic fields at time t are determined by the crack path at a retarded time t-tau(d), where the delay time tau(d) scales with the ratio of l(nl) and the typical wave speed c(nl...
متن کاملmachinability investigation of inconel 657 in high-speed turning
a high strength nickel chromium alloy (50cr-50ni-nb alloy), commonly referred to as in-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. the purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of inconel 657. the considered parameters...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Naval Architects of Japan
سال: 2000
ISSN: 1884-2070,0514-8499
DOI: 10.2534/jjasnaoe1968.2000.131