A general model for rectangular footings part I: optimal surface

Design of Isolated Footings of Rectangular Form Using a New Model

In the design of reinforced concrete rectangular footings subject to axial load and flexure in two directions, there are different pressures in the four corners, these are exercised by soil. In this paper, a mathematical model is developed to take into account the real pressure of soil acting on the contact surface of the footings, these pressures are presented in terms of the mechanical elemen...

ISLAMIC MEDICAL JURISPRUDENCE PART I: GENERAL ASPEC TS AND PRINCIPLES

Islamic medical jurisprudence, which is the subjectconcemed with the application of Islamic laws to the area of medicine, has never been discussed as an independent field of jurisprudence, although several selected topics, especially those concerning food and beverages, sexuality, death, wounds and injuries, and doctor-patient relations have been more discussed than others. The results of a...

A Simple General-purpose I-V Model for All Operating Modes of Deep Submicron MOSFETs

A simple general-purpose I-V model for all operating modes of deep-submicron MOSFETs is presented. Considering the most dominant short channel effects with simple equations including few extra parameters, a reasonable trade-off between simplicity and accuracy is established. To further improve the accuracy, model parameters are optimized over various channel widths and full range of operating v...

Parametric Optimal Design Part I

Three - Dimensional I nteractions in a Two - Segment Kinetic Chain . Part I : General Model

The motion of a body segment is determined by joint torques and by the motions of the segments proximal or distal to it. This paper describes a threedimensional model that was used to determine the effects of the shoulder and elbow joint torques and of the upper trunk and arm motions on the angular accelerations of the arm segments during baseball pitching. Equations were developed to fractiona...