A Highly Linear Low-Noise Amplifier
نویسندگان
چکیده
منابع مشابه
Highly Linear Low Noise Amplifier
The CDMA standard operating over the wireless environment along with various other wireless standards places stringent specifications on the RF Front end. Due to possible large interference signal tones at the receiver end along with the carrier, the Low Noise Amplifier (LNA) is expected to provide high linearity, thus preventing the inter-modulation tones created by the interference signal fro...
متن کاملA Concurrent Dual-Band Low Noise Amplifier for GNSS Receivers
In this paper, a new design of concurrent dual-band Low Noise Amplifier (LNA) for multi-band single-channel Global Navigation Satellite System (GNSS) receivers is proposed. This new structure is able to operate concurrently at frequency of 1.2 and 1.57 GHz. Parallel and series resonance parts are employed in the input matching in order to achieve concurrent performance. With respect to used pse...
متن کاملA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملA Broadband Low-Noise-Amplifier
This report describes the design of a two-stage broadband low-noise-amplifier (LNA) for the frequency range from 3 GHz to 9 GHz, using GaAs MESFETs with an ft of 20 GHz. The passive components were implemented with microstrips. In the frequency band of operation, the achieved noise figure (NF) is within 0.5 dB from the minimum NF of a single transistor, the power gain is 15 dB, flat within 1 dB...
متن کاملA Low Noise Cascode Amplifier
A low noise amplifier has been designed using a 2SK117 N channel J-FET as the input device in a cascode [1] configuration. Noise measurements on this amplifier yield a low frequency noise current of 0.25 fA/Yfu and a voltage noise of less than 1.2 n V NHz in the 500 Hz to 50 kHz region. Bloyet et al. [2] suggest a figure of merit of the product of the noise voltage and current as being appropri...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Microwave Theory and Techniques
سال: 2006
ISSN: 0018-9480
DOI: 10.1109/tmtt.2006.885889