A high‐power quality battery charger for light electric vehicle using switched inductor PFC converter
نویسندگان
چکیده
منابع مشابه
On electric vehicle battery charger modeling
The increase of electric vehicle (EV) battery chargers connected to electric networks could lead to future harmonic problems in power systems. These loads are nonlinear devices that inject harmonic currents and pollute network voltages. Thus, battery charger modeling must be studied in detail to determine their harmonic emissions and prevent future problems. This paper investigates EV battery c...
متن کاملA Multilevel Boost Converter Using Switched Inductor
This paper presents a new single stage DC-DC multilevel boost converter topology with very high voltage gain ratio. It is a Pulse width modulation (PWM) based switched inductor multilevel boost converter (SIMLC) consisting of two switched inductors, 2N+2 Diodes, 2N-1 Capacitors for N level boost converter. High switching frequency has been used to decrease component size. The proposed converter...
متن کاملZero Voltage Switched Full Bridge Converters for the Battery Charger of Electric Vehicle
This paper illustrates the study of three isolated zero voltage switched (ZVS) PWM full bridge (FB) converters to charge the high voltage battery in the charger of electric vehicle (EV). EV battery chargers have several challenges such as high efficiency, high reliability, low cost, isolation, and high power density. The cost of magnetic and filter components in the battery charger is reduced w...
متن کاملContactless Power Transfer System for Electric Vehicle Battery Charger
Yuichi Nagatsuka, Shingo Noguchi, Yasuyoshi Kaneko, Shigeru Abe, Tomio Yasuda, Kazuhiko Ida, Akira Suzuki, and Ryoichi Yamanouchi Saitama University, 255 Shimo-Okubo, Sakura-ku, Saitama-shi, Saitama 338-8570, Japan Technova Inc., 13th Fl. The Imperial Hotel Tower, 1-1 Uchisaiwai-cho 1-chome, Chiyoda-ku, Tokyo 100-0011, Japan Aisin AW Co., Ltd., 10 Takane, Fujii-cho, Anjo City, Aichi 444-1192, J...
متن کاملA Multirate Digital Controller for a 1.5-kW Electric Vehicle Battery Charger
This paper describes a power electronic system that, among other possibilities, can be used to charge electric vehicle batteries. A large-signal linear multirate digital controller for the charging current permits the charger to track and deliver a desired current trajectory for a wide range of loads. This controller simultaneously ensures that the charger draws power from the electric utility ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IET Power Electronics
سال: 2020
ISSN: 1755-4535,1755-4543
DOI: 10.1049/pel2.12016