A low-power circuit for piezoelectric vibration control by synchronized switching on voltage sources
نویسندگان
چکیده
منابع مشابه
A Low Frequency Vibration Control by Synchronized Switching on Negative Capacitance and Voltage Sources
Synchronized switch damping (SSD) techniques have recently been developed, as an alternative to active vibration control techniques, to address the problem of structure vibration control. In these techniques, a piezoelectric patch is bonded on the vibrating structure and shunted by a network of electrical elements. During the structure motion, the piezoelectric patch is connected and disconnect...
متن کاملA Low Cost Sensorless Control Drive Circuit for of Low Voltage Switched Reluctance Motor
Shaft position sensing is an essential part of switched reluctance (SR) motor drive In order to synchronize the pulses of phase current with the period of rising inductance of the proper motor phase. Direct sensors such as, Hall effect and optical encoder are commonly used in SR motors. The purpose of this paper is to present an indirect shaft positioning sensing known as "sensorless " control ...
متن کاملPiezoelectric Power Requirements for Active Vibration Control
This paper presents a method for predicting the power consumption of piezoelectric actuators utilized for active vibration control. Analytical developments and experimental tests show that the maximum power required to control a structure using surface-bonded piezoelectric actuators is independent of the dynamics between the piezoelectric actuator and the host structure. The results demonstrate...
متن کاملLow Input Voltage Switching Amplifiers for Piezoelectric Actuators
The Inertially Stabilized Rifle is a new stabilized rifle system that can eliminate the disturbances induced by the shooter. Recurve actuator is used in this system to provide the precise movement of the rifle barrel. In such a portable device, only low voltage electrical sources are available yet the piezoelectric actuator needs high voltage to drive the actuator. The actuators consume little ...
متن کاملResearch of Low Voltage Shore Power Supply Used on Shipping Based on Sliding Control
In order to solve the problem of fuel pollution, the diesel fuel for power generation of marine was abandoned and shore power supply have been proposed at the historic moment. The Shore Power Supply which needs transferring 380V/50Hz to 450V/60Hz is used on shipping who need this kind of power, so effectively curbs the emissions of pollution gas into the air, and achieves the purpose of improvi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sensors and Actuators A: Physical
سال: 2010
ISSN: 0924-4247
DOI: 10.1016/j.sna.2010.04.012