A Method for Testing Shear Strength of Brazed Joint
نویسندگان
چکیده
منابع مشابه
Development of a New Method for T-joint Specimens Testing under Shear Loading
Nonstandard tests are necessary for analyses and verification of new developed structural and technological solutions with application of composite materials. One of the most critical primary structural parts of a typical aerospace structure is T-joint. This structural element is loaded mainly in shear, bending, peel and tension. The paper is focused on the shear loading simulations. The aim of...
متن کاملA new method for shear bond strength measurement
Modeling the tensile strength of paper has been a topic of interest over the last few decades. Fibre properties and fibre network properties are the two main sets of inputs required for any such analytical model. Out of these, the most difficult quantity to measure is the “Fibre-Fibre Shear Bond Strength”. No reliable method exists for the measurement of this quantity. This paper reports a simp...
متن کاملEffect of NOCOLOK® flux dry-off temperature on brazed joint strength of aluminum-based heat exchangers
During the brazing of aluminum-based heat exchangers, the flux dry-off temperature plays a crucial role to get sound joints with maximum strength. In the present study, the NOCOLOK® flux consists of two phases of K2AlF5.H2O and KAlF4 with a melting point around 580 °C was used for brazing AA3003 as base metal with a clad-coating of AA4343 as filler metal. The slurry was applied on the joints an...
متن کاملEffect of NOCOLOK® flux dry-off temperature on brazed joint strength of aluminum-based heat exchangers
During the brazing of aluminum-based heat exchangers, the flux dry-off temperature plays a crucial role to get sound joints with maximum strength. In the present study, the NOCOLOK® flux consists of two phases of K2AlF5.H2O and KAlF4 with a melting point around 580 °C was used for brazing AA3003 as base metal with a clad-coating of AA4343 as filler metal. The slurry was applied on the joints an...
متن کاملA Test Method for the Determination of Shear Modulus and Shear Strength
Thi« report presents a method for determining shear modulus and shear strength of unidirectional flber-relnforced composites. The method Incorporates data from unlaxlal tensile and/or oompresslve tests at fiber orientations of 0, 45, and 90 degrees. The approach presented requires fewer specimens for shear strength determinations than current exlstinc procedures. ^ Distribution of this abstract...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 1967
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.36.633