A method of electronic ballast fluorescent lamps with low harmonic distortion
نویسندگان
چکیده
منابع مشابه
Design and Implementation of Uninterruptible Power Supplies for Fluorescent Lamps with Electronic Ballast
This paper is concerned with the design and implementation of high performance uninterruptible power supplies (UPS) for fluorescent lamps with electronic ballast. The UPS design is based on the capacity and voltage ratings of the lighting equipment. The current-predicted control technique is used to control the half-bridge switch-mode rectifier so as to improve the power factor and reduce the c...
متن کاملAn Electronic Ballast for Fluorescent Lamps with No Series Passive Elements
∗ Corresponding author Abstract -This exploratory study examined the possibility of driving a fluorescent lamp at high frequency with no serially connected passive elements. The proposed driver is a full bridge stage controlled by the phase shifted PWM scheme. Current feedback was used to stabilize the average of the rectified lamp current to a set value. The experimental results of this resear...
متن کاملAdvanced Design of a Low-Cost Electronic Ballast with PFC for HPS Lamps
In this paper, an advanced design of a low-cost electronic ballast with PFC for HPS lamps is presented. The inverter stage is based on LCC parallel-series inverter with resonant current mode control. This control method avoids the inverter handling any reactive energy, minimizing both switching and conduction losses. Also, the design performs a natural power control without exceeding the maximu...
متن کاملA Dimmable High Power Factor Electronic Ballast for Compact Fluorescent Lamps
........................................................................................................................................... ii Acknowledgements .......................................................................................................................... v Chapter
متن کاملA MHz Electronic Ballast for Automotive-Type HID Lamps
The compatibility of the Current Sourcing Push Pull Resonant Inverter (CS-PPRI) with the driving requirements of HID lamps designated for automotive headlight applications was investigated theoretically, by simulation and experimentally. The study reveals that a based ballast (CS-PPRI) complies with the automotive requirement of very fast warm up. The experimental ballast was run under Zero Vol...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Illuminating Engineering Institute of Japan
سال: 1998
ISSN: 0019-2341,1349-838X,2185-1506
DOI: 10.2150/jieij1980.82.appendix_58