A Micro-defect Detection of Cold Rolled Steel
نویسندگان
چکیده
منابع مشابه
Mechanical Property Determination of Heavy Steel Plates and Cold Rolled Steel Sheets by Micro-magnetic Ndt
The presentation is to results recently obtained in collaborative research in the European steel programme performed by Fraunhofer-IZFP and co-operative steel industry producing rolling products. The objective was and is to characterize i.e. to predict mechanical properties like hardness, yield strength, tensile strength, deep drawing parameters rm and ∆r, etc., mainly online by use of contact-...
متن کاملGrain Refinement of Dual Phase Steel via Tempering of Cold-Rolled Martensite
A microstructure consisting of ultrafine grained (UFG) ferrite with average grain size of ~ 0.7 µm and dispersed nano-sized carbides was produced by cold-rolling and tempering of the martensite starting microstructure in a low carbon steel. Subsequently, fine grained dual phase (DP) steel consisting of equiaxed ferrite grains with average size of ~ 5 µm and martensite islands with average size ...
متن کاملKinetics of Austenite Recrystallization during the Annealing of Cold-rolled Fe-Mn-Al-C Steel
In the current study, the recrystallization behavior of 75% cold-rolled Fe-22Mn-10Al-1.4C steel during annealing at 750, 770, 790, 810, and 830°C was studied. X-ray diffraction patterns and optical microscopy were used to characterize microstructures. The Vickers Micro-hardness test was used to characterize recrystallization kinetics during annealing. Johnson-Mehl-Avrami-Kolmogorov (JMAK) model...
متن کاملGrain Growth in a Low-Loss Cold-Rolled Motor-Lamination Steel
This paper attempts to determine the mechanisms governing the grain growth process that occurs during lamination annealing of a cold-rolled, motor-lamination steel. A new simulation approach linking a Monte Carlo model, with EBSD scans used as input, has been employed to incorporate the effects of crystallographic texture on the simulated grain growth process. The results from the texture analy...
متن کاملDeformation Microstructure and Texture in a Cold-Rolled Austenitic Steel with Low Stacking-Fault Energy
Deformation microstructure and texture in a cold-rolled austenitic steel 310S with low stacking fault energy (SFE) have been investigated by SEM and TEM. When 310S plates were rolled by 95% in thickness reduction, a remarkable development of the brass-type preferred orientation was confirmed by X-ray diffraction. SEM observations of the specimens with such texture exhibited a layered structure ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Institute of Control, Robotics and Systems
سال: 2016
ISSN: 1976-5622
DOI: 10.5302/j.icros.2016.16.0023