A monolithic, constant-fraction discriminator using distributed R-C delay line shaping

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Off-line correction for excessive constant-fraction-discriminator walk in neutron time-of-flight experiments

A method for reducing excessive constant-fraction-discriminator walk that utilizes experimental data in the off-line analysis stage is introduced. Excessive walk is defined here as any walk that leads to an overall timing resolution that is much greater than the intrinsic timing resolution of the detection system. The method is able to reduce the contribution to the overall timing resolution fr...

متن کامل

Vector Regression degradation modeling for Constant Fraction Discriminator

In the nuclear industries, the electronic signal processing unit plays a key role in the data processing, data analysis, control mechanism and more importantly safety of the nuclear reactor. The processing unit comprises of different modules that process pulse and current signals from detector and constant fraction discriminator which has higher criticality is one of them. Earlier the reliabili...

متن کامل

On-Line Error Detecting Constant Delay Adder

Fault tolerance requires the inclusion of redundant information. In this paper an on-line error detecting adder is presented in which the redundant information serves a dual purpose. It provides fault tolerance during the arithmetic operations while also providing a method by which addition is constrained to become a constant delay operation regardless of the word size of the operands.

متن کامل

A Comparison of Two Delay Line Discriminator Implementations for Low Cost Phase Noise Measurement

This paper focuses on low cost production testing of the far-out phase noise of PLL ICs using the delay line discriminator method. It describes two different delay line discriminator (DLD) implementations for phase noise measurements at large frequency offsets from the carrier. The calibration method using an FM calibration signal is described in detail, both mathematically and graphically. The...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: IEEE Transactions on Nuclear Science

سال: 1996

ISSN: 0018-9499,1558-1578

DOI: 10.1109/23.507173