A New Hot Cracking Determination Test
نویسندگان
چکیده
منابع مشابه
Effect of Welding Parameters on Hot Cracking Susceptibility
The varestraint cracking test was carried out to assess the hot cracking tendency of alloy 800 at different welding conditions and augmented strain levels. The test results revealed that the hot cracking susceptibility of alloy 800 increases with increasing the heat input and augmented strain levels. This emphasizes the role of constraint either internally induced or externally applied to the w...
متن کاملEffect of Nonmetallic Inclusions on Steel Welds Metal Hot Cracking
B. Z orc, W elding I nstitute, L jubljana, S lovenia; M . I mamović, Un iversity of Zenica, Faculty of Mechanical Engineering, Zenica, B a nd H; A. Nagode, B. Kosec, L. Kosec, University of Ljubljana, Faculty of Natural Sciences and Engineering, Ljubljana, Slovenia; A. Stoić, I. Samardžić, University of Osijek, Mechanical Engineering Faculty, Slavonski Brod, Croatia Intercrystally distributed n...
متن کاملAcoustic Emission during Stress Corrosion Cracking Test
AE monitoring from various types of stress corrosion cracking (SCC) has been conducted for the past 15 years in our laboratory. This paper discusses AE results of active-path dissolution-type SCC of austenitic stainless steel in chloride solution and fused salt, fluoride and polythionic acid solutions, brass in ammonia (Mattosson's solution), and carbon steels in nitrite solution. Transgranular...
متن کاملEvaluation of a new latex test and a new enzyme immunoassay for determination of rubella immunity.
A new enzyme immunoassay (Rubenostika; Organon Teknika, Turnhout, Belgium), a new latex agglutination test (Rubalex; Orion Diagnostica, Espoo, Finland), and three other accepted methods for the determination of rubella immunity were compared with a standard hemagglutination inhibition assay. Of 224 serum samples tested, 54 (24%) were nonreactive and 24 (11%) were low titered. All procedures wer...
متن کاملHot Deformation Behavior of Haynes 25 by the Hot Tensile Test
In the present work, hot tensile behavior of Haynes 25 Co-base alloy was investigated in the temperature range of 950-1200 ˚C and 0.1 s-1. Thermodynamic calculations showed that M23C6 and M6C carbides were stable below 1000 ˚C and above 1050 ˚C, respectively. Stress-strain curves also indicated an unusual trend of strain fracture. It was observed that with increasing temperature from 950 to 105...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 1957
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.26.511