A novel method for joining aluminum foil and alumina by polysiloxane coating
نویسندگان
چکیده
منابع مشابه
A Low Cost Method for Manufacturing of Aluminum / Alumina Composite by Anodizing and CRB Process :
A Low Cost Method for Manufacturing of Aluminum/Alumina Composite by Anodizing and CRB Process: Roohollah Jamaati1; Mohammad Reza Toroghinejad1; E. Zahrani1; 1Isfahan University of Technology In this work, Al/Al2O3 composite strips are manufactured by a low cost method consist cold roll bonding (CRB) process of anodized aluminum strips. This technique has the flexibility to control the volume f...
متن کاملConsideration of Alumina Coating Fabricated by Sol-gel Method as MHD Coating against PbLi
Development of effective electrical magnetohydrodynamic (MHD) coating insulating induced current path is one of key fusion technologies for fusion blanket research and development. Electrical insulation coating is extremely important for lead lithium (PbLi) MHD thermofluid study from pointview of secure electric insulating wall condition. The alumina (Al2O3) coatings fabricated by a sol-gel met...
متن کاملShielding a room using aluminum foil
A local hospital was interested in shielding some sensitive equipment and contemplated installing a shielded room. The room under consideration was the typical laminated wood core panel with galvanized steel on both surfaces, with a RF shielded door, honeycomb air vent panels and filters for ac power, telephone and any other signals, meeting the shielding effectiveness requirements of MIL-STD-2...
متن کاملA Novel Method for Preparation of Alumina-Supported Rhenium-Cesium Catalyst, Re-Cs/-Al2O3
Alumina-supported Cs3[Re(C2O4)3] precursor has been synthesized for preparation of Re-Cs/g-Al2O3 catalyst. Cs3[Re(C2O4)3] has been prepared from the reaction of ReCl3 with H2C2O4.2H2O and CsCl in ...
متن کاملNew Method for Preparation of Nano Alumina Powder Using Aluminum(III) Complexes by Combustion Synthesis Without Fuel
Alumina nanomaterials were synthesized via a solution combustion technique using tris-(acetylacetonato) aluminum(III) complex (1) and tris-(2-formylphenolate) aluminum(III) complex (2) at 600, and 1000 °C for 3h. The obtained data showed that the procedure without using fuel resulted in a better phase and morphology. To investigate the phase formation, powder X-ray diffraction technique was use...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 2017
ISSN: 1348-6535,1882-0743
DOI: 10.2109/jcersj2.17117