A Rational Method of Cooling Gas-Engine Cylinders
نویسندگان
چکیده
منابع مشابه
Dual-Fuelling of a Direct-Injection Automotive Diesel Engine by Diesel-Gas Method
Use of liquefied petroleum gas (LPG) in compression-ignition (C-I) engines has always been considered important in the diesel engineering field. This is due to its easy accessibility and good combustion characteristics. In this paper the application of LPG fuel along with diesel oil in a direct- injection automotive diesel engine is experimentally investigated. In order to convert the pure dies...
متن کاملASSESSING THE EFFECT OF BLOCKAGE OF DIRT ON ENGINE RADIATOR IN THE ENGINE COOLING SYSTEM
This thesis looked at the effect of clay and silt soil blocking the heat transfer area of the radiator and its effect on the engine coolant through the conduct of experiments and a mathematical model developed. The results indicated that the percentage area covered resulted in a proportional increase of the inlet and outlet temperatures of the coolant in the radiator. The mathematically mode...
متن کاملCooling of a One-Dimensional Bose Gas.
We experimentally study the dynamics of a degenerate one-dimensional Bose gas that is subject to a continuous outcoupling of atoms. Although standard evaporative cooling is rendered ineffective by the absence of thermalizing collisions in this system, we observe substantial cooling. This cooling proceeds through homogeneous particle dissipation and many-body dephasing, enabling the preparation ...
متن کاملFlue Gas Cooling
When waste heat is not utilized, cooling of flue gases in special cooling chambers becomes necessary, if the dust':'collecting and associated equipment is constructed of metal. The two most common methods of cooling are by dilution with ambient air, and by evaporation of water in the gas stream. Usually, they are combined. Load sharing depends largely on acceptable visibility of stack effluvia ...
متن کاملAir-Cooling Effects of Fins on a Motorcycle Engine∗
Effects of the number of fins, fin pitch and wind velocity on air-cooling were investigated using experimental cylinders for an air-cooled engine of a motorcycle. Experimental cylinders that had a various number of fins and fin pitches were tested in a wind tunnel. Then the temperature inside of the cylinder, on the surface of the fins and in the space between the fins was measured. Results ind...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Scientific American
سال: 1906
ISSN: 0036-8733
DOI: 10.1038/scientificamerican01201906-70