A self-testing method of large analog circuits in electronic embedded systems
نویسندگان
چکیده
منابع مشابه
Prognostics Method for Analog Electronic Circuits
Analog electronic circuits are an integral part of many industrial systems. Failure in such analog circuits during field operation can have severe economic implications. The presence of an expert system that can provide advance warnings on circuit failures can minimize the downtime and improve the reliability of electrical systems. Through successive refinement of circuit’s response to a sweep ...
متن کاملA Simple Fault Diagnosis Method for Analog Parts of Electronic Embedded Systems
− A new simple method of single soft fault detection and localization of analog parts in embedded electronic systems controlled by microcontrollers is presented. In the pre-testing stage of the method a fault dictionary is created based on the map of localization curves. In the measurement stage the time response to a stimulating square impulse of the analog part is applied to the input of the ...
متن کاملTesting of Analog Parts of Electronic Embedded Systems with Limited Access to Internal Nodes
A new class of multi-port methods based on extension of input-output two-port methods of soft fault diagnosis of passive elements in analog circuits is presented. It uses accessible internal nodes of the tested analog circuit for additional measurements of circuit time responses. Thanks to this, the fault resolution increases, that is we obtain better fault localization coverage.
متن کاملFault Diagnosis of Fully Differential Circuits in Electronic Embedded Systems
− A new Built-In-Self-Test scheme for diagnosis of analog fully differential circuits in embedded mixed-signal microsystems is presented. The measurement procedure is realized by the internal resources of the microcontroller. The real and imaginary parts of the output differential voltage are measured with common-mode excitation of the circuit under test (CUT). The diagnosis procedure is based ...
متن کاملthree dimensional simulation and testing of radiative electromagnetic wave characteristics on electronic circuits using fdtd method
voltages and currents are induced into electronic circuit boards as electromagnetic waves are radiated on them. the strength of induction depends on the wavefront and the circuit board characteristics. in this paper, by solving maxwell’s equations using fdtd method and then by extending it by three dimensional simulation using the gpml criteria for boundary conditions and tf/sf technique, effec...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2010
ISSN: 1742-6596
DOI: 10.1088/1742-6596/238/1/012013