A Simple Approach for Designing a Filter on Microstrip Lines
نویسندگان
چکیده
منابع مشابه
Designing Microstrip Bandpass Filter at 3.2 GHz
Abstract: Bandpass filters play a significant role in wireless communication systems. Transmitted and received signals have to be filtered at a certain center frequency with a specific bandwidth. In designing of microstrip filters, the first step is to carry out an approximated calculation based on using of concentrated components like inductors and capacitors. After getting the specifications ...
متن کاملa new approach to credibility premium for zero-inflated poisson models for panel data
هدف اصلی از این تحقیق به دست آوردن و مقایسه حق بیمه باورمندی در مدل های شمارشی گزارش نشده برای داده های طولی می باشد. در این تحقیق حق بیمه های پبش گویی بر اساس توابع ضرر مربع خطا و نمایی محاسبه شده و با هم مقایسه می شود. تمایل به گرفتن پاداش و جایزه یکی از دلایل مهم برای گزارش ندادن تصادفات می باشد و افراد برای استفاده از تخفیف اغلب از گزارش تصادفات با هزینه پائین خودداری می کنند، در این تحقیق ...
15 صفحه اولdesigning a fast locking pll
a phase-locked loop (pll) based frequency synthesizer is an important circuit that is used in many applications, especially in communication systems such as ethernet receivers, disk drive read/write channels, digital mobile receivers, high-speed memory interfaces, system clock recovery and wireless communication system. other than requiring good signal purity such as low phase noise and low spu...
QSmith A Simple Tool for Designing Matched Transmission Lines
– A sample transmission line, which is laid at the bottom of the GUI. There is a slider in the line that indicates the position of measurement probes. The probes are measuring the information of the line, toward the load. By default, the probe is laid next to the load. Thus the initial impedance, measured by the probe is the same as the load. It is possible to enter desired values as a load. Un...
متن کاملA simple de-embeding method for on-wafer RF CMOS FET using two microstrip lines
This letter deals with the de-embedding of on-wafer CMOS FETs embedded in symmetrical and reciprocals pads. A de-embedding method, that uses a calibrated vector network analyzer and two microstrip lines fabricated on a lossy SiO2-Si substrate, is introduced. The proposed method not only allows the characterization on the interconnection lines but also allows the characterization of the CMOS pad...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Engineering Letters : Journal of Engineering and Applied Sciences
سال: 2019
ISSN: 2466-4677,2466-4847
DOI: 10.18485/aeletters.2019.4.1.3