A study of transverse bowing defect in cold roll-forming asymmetric corrugated channels

Stress Analysis and Energy Estimation in Cold-Roll Forming Process

In this article, stress analysis and energy estimation during cold-roll forming of symmetrical channel sections have been discussed. Geometry of sheet strip is pre-estimated by a shape function. Then longitudinal, transversal and shear strains have been calculated. Using both the Levy-Mises and the Prandtl Reuss equations, and also considering the Bauschinger effect, stress distributions have b...

Cold roll forming process pdf

Stress Analysis and Energy Estimation in Cold-Roll Forming Process

In this article, stress analysis and energy estimation during cold-roll forming of symmetrical channel sections have been discussed. Geometry of sheet strip is pre-estimated by a shape function. Then longitudinal, transversal and shear strains have been calculated. Using both the Levy-Mises and the Prandtl Reuss equations, and also considering the Bauschinger effect, stress distributions have b...

Ovality and Bow Defect of Pre-punched Sheets in Roll Forming of Trapezoidal Sections

Roll forming process is used for manufacturing sheet metal parts by successive bending and creating the final shape with gradual deformation. In this article, deformation of a pre-punched sheet due to the roll forming process was studied. Two main defects in the roll forming process are ovality of holes and bow defect. The ovality of the hole is influenced by the process parameters including sh...

Determination of Buckling Limit of Strain in Cold Roll Forming through Finite Element Analysis

In this study, "Buckling Limit of Strain" (B.L.S.) is introduced as one of the most important limiting factors in cold roll forming process. B.L.S. is calculated by the finite element procedure. Then for two particular processes with existing analysis and experimental results, B.L.S. has been determined and evaluated. LUSAS 12.3 is used for finite element analysis. The results show that when bu...