A STUDY ON COLLAPSE MODE AND PLASTIC DEFORMATION CAPACITY OF H-SHAPED STEEL BEAMS UNDER SHEAR BENDING

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Experimental Investigations into the Collapse of Simple and Reinforced Thin-Walled Channel Beams under Bending Loads

In this paper, collapse behavior of simple and reinforced thin-walled channel- section beams, subjected to three- point bending, is investigated. Many simple channel- section beams of different geometry and some reinforced ones were tested, and their strengths after collapse were obtained thoroughly. Since the available theories in this area are complicated and little attention has been paid to...

متن کامل

Behavior of Steel–Concrete Composite Beams with Corroded Shear Studs Under Negative Bending Moment

The behavior of corroded steel–concrete composite beams under hogging moment was studied by experimental investigation and theoretical analysis. A total of eight specimens, six of which had corroded shear studs, were tested. The corrosion rate of studs ranged from 0 to approximately 50%. The constant-current accelerated corrosion method was adopted to accelerate the corrosion process. The loadi...

متن کامل

Experimental Investigations into the Collapse of Simple and Reinforced Thin-Walled Channel Beams under Bending Loads

In this paper, collapse behavior of simple and reinforced thin-walled channel- section beams, subjected to three- point bending, is investigated. Many simple channel- section beams of different geometry and some reinforced ones were tested, and their strengths after collapse were obtained thoroughly. Since the available theories in this area are complicated and little attention has been paid to...

متن کامل

A Simple Approach to Predict the Shear Capacity and Failure Mode of Fix-ended Reinforced Concrete Deep Beams based on Experimental Study

Reinforced Concrete (RC) deep beams are commonly used in structural design to transfer vertical loads when there is a vertical discontinuity in the load path. Due to their deep geometry, the force distribution within the RC deep beams is very different than the RC shallow beams. There are some strut and tie model (STM) already been developed for RC deep beams. However, most of these models are ...

متن کامل

A Parametric Study on the Progressive Collapse Potential of Steel Buildings under Truck Collision

In this paper, the initiation and propagation of structural damage in a building due to the truck collision to one of its corner columns were investigated. For this purpose, a three-dimensional 4-story moment resisting steel frame with intermediate ductility was considered. The structure was designed using ETABS software under standard dead, live, and earthquake loads, and then impact loading w...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Structural and Construction Engineering (Transactions of AIJ)

سال: 2001

ISSN: 1340-4202,1881-8153

DOI: 10.3130/aijs.66.185