A Study on Countermeasures against Wind-Induced Cable Vibrations in Cable-Stayed Bridge by Changing Vibration Modes.
نویسندگان
چکیده
منابع مشابه
Feasibility Study of Micro-Wind Turbines for Powering Wireless Sensors on a Cable-Stayed Bridge
In this study, the feasibility of using micro-wind turbines to power wireless sensors on a cable-stayed bridge is comprehensively investigated. To this end, the wind environment around a bridge onto which a turbine is installed is examined, as is the power consumption of a wireless sensor. Feasible alternators and rotors are then carefully selected to make an effective small wind generator (kno...
متن کاملCable-Stayed Bridges: A Case Study for Vibration-Based Cable Tension Estimation
A cable-stayed bridge recently constructed by the Ohio Department of Transportation incorporates measures put forth by a Federal Highway Administration study to mitigate stay motion. In following recent trends, the stays at this bridge are built without the use of grout for the purposes of inspection and, if necessary, replacement. Several experiments were performed to determine the viability o...
متن کاملSTRUCTURAL ASPECTS OF CABLE-STAYED BRIDGE DESIGN by EDWARD
STRUCTURAL ASPECTS OF CABLE-STAYED BRIDGE DESIGN
متن کاملHealth Condition Evaluation of Cable-Stayed Bridge Driven by Dissimilarity Measures of Grouped Cable Forces
An index system for the health-status evaluation of cable-stayed bridges is presented based on a set of dissimilarity measures (abbr. DM) of the cable force of grouped cables. The DMs and its corresponding health status labels derived by the serviceability limit states of a bridge are determined by the combination of the finite element method and the influence matrix method. The Monte-Carlo met...
متن کاملCable optimization of a long span cable stayed bridge in La Coruña (Spain)
This document describes an optimization problem of cable cross section of a cable stayed bridge considering constraints of cable stress and deck displacement. Since the bridge is still in study phase, the geometry and the mechanical characteristics are subjected to changes. In order to avoid creating different structural models, a program was produced to construct a model from geometrical and m...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 2000
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.66.2173