A study on Nb-V microalloyed steel for 460 MPa grade H-section columns

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

a study on thermodynamic models for simulation of 1,3 butadiene purification columns

attempts have been made to study the thermodynamic behavior of 1,3 butadiene purification columns with the aim of retrofitting those columns to more energy efficient separation schemes. 1,3 butadiene is purified in two columns in series through being separated from methyl acetylene and 1,2 butadiene in the first and second column respectively. comparisons have been made among different therm...

SEISMIC PERFORMANCE OF CROSS-SHAPED COLUMNS WITH 500 MPa GRADE REINFORCING STEEL BARS

Original scientific paper Based on the experimental research on three cross-shaped columns with 500 MPa grade reinforcing steel bars, the contrastive analysis is made on failure mode, bearing capacity and displacement ductility of each column specimens with different stirrup spacing under the identical axial compression ratio. The research shows that the longitudinal bars yield before spalling ...

متن کامل

a study of the flow behaviour of a nb-v-ti microalloyed steel during hot compression test

the flow stress of steel depends significantly on microstructural changes taken place during hot deformation processes. in hot deformation processes, the flow stress of steel is influenced by two main metallurgical phenomena, i.e. recovery and recrystallization, along with its chemical composition and thermo-mechanical parameters. the final mechanical properties of steel are also determined by ...

متن کامل

Simulation Study on Thermo-Mechanical Controlled Process of 800 MPa-Grade Steel for Hydropower Penstocks

The thermo-mechanical controlled process (TMCP) of 800-MPa-grade non-quenched tempered steel used for penstocks was simulated on a Gleeble-3500 thermo-mechanical simulator. The effect of the finish cooling temperature (FCT) which ranged from 350–550 ◦C on the microstructure and mechanical properties was studied. The microstructure of TMCP specimens is primarily composed of lath bainite (LB) and...

متن کامل

Effect of austenitising and deformation temperatures on dynamic recrystallisation in Nb-Ti microalloyed steel

An investigation into influence of the austenitising temperature and the austenite deformation temperature on Nb precipitation and recrystallisation kinetics was carried out for a steel containing 0.081C-0.021Ti-0.064Nb (wt. %). The austenite grain structure was correlated to the dispersive properties of Nb atom clustering and precipitation. Irrespective of the austenitising temperature, deform...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Constructional Steel Research

سال: 2020

ISSN: 0143-974X

DOI: 10.1016/j.jcsr.2020.106112