A study on one dc reactor type three-phase current limiter
نویسندگان
چکیده
منابع مشابه
A Three-Phase Current-Fed Push–Pull DC–DC Converter
In this paper, a new three-phase current-fed push– pull dc–dc converter is proposed. This converter uses a highfrequency three-phase transformer that provides galvanic isolation between the power source and the load. The three active switches are connected to the same reference, which simplifies the gate drive circuitry. Reduction of the input current ripple and the output voltage ripple is ach...
متن کاملA Lecture on Current Limiter
A lecture on current limiter intended specifically for engineering students pursuing specialization with Electrical and Electronics engineering is proposed in this paper. The important information which doesn’t appear in text books are presented to the students. A general overview of different techniques of limiting fault current in electric power systems with special emphasis on two types of c...
متن کاملSingle-Phase Resistive Superconductor Electrical Current Limiter
This paper presents the analysis, design, construction and ac test results of low voltage single-phase resistive superconductor electrical current limiters. Two different types of resistive superconductor current limiter are presented: the first one is built with three concentric, cylindrical and helicoidal coils connected in parallel and the second one is built with two superposed cylindrical ...
متن کاملA ZVS-PWM Three-Phase Current-Fed Push-Pull DC-DC Converter
In this paper, a ZVS-PWM three-phase current fed push–pull dc–dc converter with reduced harmonics is proposed. When compared to single-phase topologies, the three-phase dc–dc conversion increases the power density, uses the magnetic core of the transformer more efficiently, reduces the stress on switches, and requires smaller filters since the frequency for its design is higher. The proposed co...
متن کاملSpeed Control of A Three Phase Current Forced Synchronous Machine Drive Based on A Simple Method
In this paper, a new method is proposed for the speed control of a three-phase current forced synchronous machine drive. This metohd is based on the use of an approximate constant commutation safety margin angle in the output thyristor bridge of the drive system as well as on the compenastion of stator magnetization reaction. The commutation process in the output converter of the machine driv...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Power and Energy
سال: 1999
ISSN: 0385-4213,1348-8147
DOI: 10.1541/ieejpes1990.119.11_1166