A Texture Based Model for Polycrystal Plasticity
نویسندگان
چکیده
منابع مشابه
Coupling discrete dislocation dynamics with polycrystal plasticity
Lebensohn et al. [1] recently introduced an alternative description of crystal plasticity based on a fast-Fourier transform (FFT) algorithm. The FFT approach solves for the equilibrium stress and strains under the constraint of strain compatibility for systems with periodic microstructures. As currently developed, the FFT model describes plasticity with a set of elasto-viscoplastic constitutive...
متن کاملCalibration of nanocrystal grain boundary model based on polycrystal plasticity using molecular dynamics simulations
Decohesion parameters are computed for the tilt grain boundaries through molecular simulations and the parameters are employed in a elastoplastic deformation model of a face centered cubic (FCC) nanocrystal. The calibrated continuum grain boundary model accounts for reversible elastic and irreversible inelastic separation sliding deformations. The intragranular plasticity was modeled using a ra...
متن کاملComparison of two integration schemes for a micropolar plasticity model
Micropolar plasticity provides the capability to carry out post-failure simulations of geo-structures due to microstructural considerations and embedded length scale in its formulation. An essential part of the numerical implementation of a micropolar plasticity model is the integration of the rate constitutive equations. Efficiency and robustness of the implementation hinge on the type of int...
متن کاملPlasticity of a colloidal polycrystal under cyclic shear.
We use confocal microscopy and time-resolved light scattering to investigate plasticity in a colloidal polycrystal, following the evolution of the network of grain boundaries as the sample is submitted to thousands of shear deformation cycles. The grain boundary motion is found to be ballistic, with a velocity distribution function exhibiting nontrivial power law tails. The shear-induced dynami...
متن کاملA Strain Range Dependent Cyclic Plasticity Model
Hysteresis loop curves are highly important for numerical simulations of materials deformation under cyclic loadings. The models mainly take account of only the tensile half of the stabilized cycle in hysteresis loop for identification of the constants which don’t vary with accumulation of plastic strain and strain range of the hysteresis loop. This approach may be quite erroneous particularly ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science Forum
سال: 2005
ISSN: 1662-9752
DOI: 10.4028/www.scientific.net/msf.495-497.1091