A two-dimensional splashing model for investigating impingement characteristics of supercooled large droplets
نویسندگان
چکیده
منابع مشابه
investigating the feasibility of a proposed model for geometric design of deployable arch structures
deployable scissor type structures are composed of the so-called scissor-like elements (sles), which are connected to each other at an intermediate point through a pivotal connection and allow them to be folded into a compact bundle for storage or transport. several sles are connected to each other in order to form units with regular polygonal plan views. the sides and radii of the polygons are...
Supercooled large droplets in icing conditions
In March 1997 NLR investigated the icing atmosphere for aircraft by flying with an instrumented research aircraft through clouds. Liquid water content, droplet diameter distributions and air temperature were measured. Large droplets were found in air masses with a limited extent. Results from the measurement campaign are presented and compared with limits in aircraft and helicopter certificatio...
متن کاملSplashing onset in dense suspension droplets.
We investigate the impact of droplets of dense suspensions onto a solid substrate. We show that a global hydrodynamic balance is unable to predict the splash onset and propose to replace it by an energy balance at the level of the particles in the suspension. We experimentally verify that the resulting, particle-based Weber number gives a reliable, particle size and density dependent splash ons...
متن کاملTwo-dimensional infrared spectroscopy of supercooled water.
We present two-dimensional infrared (2D IR) spectra of the OD stretch vibration of isotope diluted water (HOD/H(2)O) from ambient conditions (293 K) down to the metastable supercooled regime (260 K). We observe that spectral diffusion slows down from 700 fs to 2.6 ps as we lower the temperature. A comparison between measurements performed at the magic angle with those at parallel polarization s...
متن کاملOptimization of thermal curing cycle for a large epoxy model
Heat generation in an exothermic reaction during the curing process and low thermal conductivity of the epoxy resin produces high peak temperature and temperature gradients which result in internal and residual stresses, especially in large epoxy samples. In this paper, an optimization algorithm was developed and applied to predict the thermal cure cycle to minimize the temperature peak and the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Multiphase Flow
سال: 2016
ISSN: 0301-9322
DOI: 10.1016/j.ijmultiphaseflow.2015.12.005