Abrasive wear and optimal installation angle of concrete double-horizontal shaft mixer stirring blades

Modelling Friction and Abrasive Wear of Elastomers

In order to properly model the friction and wear of elastomer materials, it is essential to understand some specific mechanical and tribological features. Mechanical characteristics of elastomer materials are different from those of metals and other relatively hard materials. Elastomers can bear large deformations, the stress-strain curves are non-linear, time and temperature dependent. When th...

Effect of Abrasive Size on Wear

Measuring Angle of Attack of Helicopter Blades

Scientific and Technical Information Office 1980 SUMMARY Systematic investigations were performed on a variety of probes to determine their potential for possible application as sensors attached to helicopter blades to measure both the instantaneous angle of attack as well as the dynamic head during actual flight operations. After some preliminary considerations a sensor of essentially spherica...

Productivity Improvement of Pre-cast Concrete Installation

The production process of pre-cast concrete installation is analyzed to investigate possible ways for onsite productivity improvement. Although manufactured construction enjoys higher quality and productivity, it is observed that it suffers delays compared to site built construction. Delay causes and respective severity are analyzed for improvement. Firstly, the production process is investigat...

Effect of Abrasive Particle Size on Abrasive Wear Resistance in Otomotive Steels

If one of the surfaces which are in touch is rough and hard, it chips the other surface due to relative motion or touching forces. The wear is called two-body abrasive wear. If there are free abrasive particles between the two bodies, the wear is called three-body abrasive wear. The free abrasive particles may be external material dust or the remains of chipping. Usually, the wear starts as a t...