Acoustic Analysis of Used Tuning Forks
نویسندگان
چکیده
منابع مشابه
Acoustic Analysis of Used Tuning Forks.
OBJECTIVE In this study, we evaluated used aluminum tuning forks (TFs) for fundamental frequencies (FF), overtones, and decay times. MATERIALS AND METHODS In total, 15 used (1 C1, 11 C2, and 3 C3) and 1 unused (C2) TFs were tuned, and the recorded sound data were analyzed using the Praat sound analysis program. RESULTS It was found that FFs of the recorded sounds produced by the used C2-TFs...
متن کاملTuning Forks and Tests
The three tuning forks generally used include : 256 Hz, 512 Hz, 1024 Hz. Most common being 512Hz. 512 because It has appropriate decay time, Less overtones and lies in speech frequency. Compressing the prongs with fingers produces around 70 dB sound and hitting against Knee or elbow 90dB. A prediction of air-bone gap can be made if tuning forks of 256, 512 and 1024 Hz are used. • Rinne test equ...
متن کاملRinne revisited: steel versus aluminum tuning forks.
OBJECTIVE (1) Determine whether tuning fork material (aluminum vs stainless steel) affects Rinne testing in the clinical assessment of conductive hearing loss (CHL). (2) Determine the relative acoustic and mechanical outputs of 512-Hz tuning forks made of aluminum and stainless steel. STUDY DESIGN Prospective, observational. SETTING Outpatient otology clinic. SUBJECTS AND METHODS Fifty su...
متن کاملPiezoelectric Quartz Tuning Forks for Scanning Probe Microscopy
In this paper the application of piezoelectric quartz tuning forks in dynamic force microscopy is described. For the introduction we give a historical overview and a comparison with traditional cantilevers. In the second section the theories for tuning forks as oscillators for the dynamic force detection are introduced and in the third section the experimental implementation is described. This ...
متن کاملChemical sensor based on microfabricated wristwatch tuning forks.
We report here a chemical sensor based on detecting the mechanical response of a thin (approximately 10-microm) polymer wire stretched across the two prongs of a wristwatch quartz tuning fork (QTF). When the fork is set to oscillate, the wire is stretched and compressed by the two prongs. The stretching/compression force changes upon adsorption of analyte molecules onto/into the polymer wire, w...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of International Advanced Otology
سال: 2017
ISSN: 1308-7649,2148-3817
DOI: 10.5152/iao.2017.2745