Active Clamp Boost Converter with Blanking Time Tuning Considered

Active Clamp Zvs Flyback Converter with Output Voltage Douler

A New, Soft-switched Boost Converter with Isolated Active Snubber

A boost converter which employs an isolated active snubber to reduce the losses caused by the reverserecovery characteristic of the boost rectifier and the turnon discharge loss of the output capacitance of the boost switch is described. The proposed isolated active snubber consists of a coupled inductor, clamp capacitor, and ground-referenced N-type MOSFET. The performance of the proposed conv...

High Gain DC-DC Converter using Active Clamp Circuit (RESEARCH NOTE)

In this paper, a boost converter with a clamp circuit is proposed for high intensity discharge (HID) lamp application. The clamp circuit provides zero voltage turn on for both main and clamp switches. Compared to conventional boost converters, the proposed converter has the following advantages: (i) high voltage gain without suffering from extreme duty ratio, (ii) low stress on the switches and...

Simulation of Active Power Factor Correction Using Boost Type Converter

With the vast development in the usage of Power electronic devices like Rectifiers (nonlinear loads) the current drawn from the line is distorted resulting in a High Total Harmonic Distortion (THD) and Low Power Factor (PF). Hence there is a continuous need for Power factor improvement and reduction of line current harmonics. The most popular topology for Active PFC is a boost converter as it d...

LM5032 Interleaved Boost Converter

The LM5032 dual current mode PWM controller contains all the features needed to control an interleaved boost converter. The two outputs operate 180 degrees out of phase and have separate current limit inputs for each channel. In addition to a high input voltage range, the controller contains all the auxiliary features needed to control a complete converter. Introduction A basic boost converter ...