Active vibration isolation of electronic components by piezocomposite clamped–clamped beam
نویسندگان
چکیده
منابع مشابه
Vibration Control of Rotating Composite Thin-walled Beam Using Piezocomposite Actuators
Aim of this research is the vibration analysis and control of rotating composite thin-walled beam containing distributed piezoelectric sensors and actuators. The formulation is based on thin-walled, single cell composite beam including the warping function, centrifugal force, Coriolis acceleration and piezoelectric effect. Adaptive capability of thin-walled beam is obtained by PVDF sensor and p...
متن کاملDecentralized control for multichannel active vibration isolation
This paper describes a theoretical and experimental investigation into an active four-mount vibration isolation system, in which electromagnetic actuators are installed in parallel with each of the four passive mounts placed between a three-dimensional piece of equipment and a vibrating base structure. Decentralized velocity feedback control is applied, where each actuator is operated independe...
متن کاملActive vibration control of smart building frames by feedback controllers
In this paper the active vibration control of a four-story shear frame instrumented with piezoelectric actuators is presented. The piezoelectric actuators are hosted on the columns in two manners and the produced controlling forces by actuators are considered in the equation of motion. The smart structure modeling and control design is carried out using MATLAB software in state space form. Subs...
متن کاملEfficiency of Active Control of Beam Vibration Using PZT Patches
This study is aimed to explore efficiency problems of using PZT patches in active vibration control of beams. The PZT patches are surface-bonded as actuators and strain gages are used as sensors. Distributed moment forcing mode is adopted to derive the control authority of actuators. Uniform beam model is applied when the mass and stiffness of PZT patches are ignored. Stepped beam model is then...
متن کاملActive Vibration Control of Smart Beam under Random Vibrations
Thepresent paper discusses active vibration control of a cantilever beam subjected to random base excitation. The smart materials used are piezoelectric patches for both as sensor and actuator, and actuation based on the surface strains. Finite element model of the smart beam is obtained using Euler-Bernoulli formulation. Positive Position Feedback (PPF) controller is proposed for active dampin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mechanical Systems and Signal Processing
سال: 2011
ISSN: 0888-3270
DOI: 10.1016/j.ymssp.2010.12.015