ADC Testing With Verification
نویسندگان
چکیده
منابع مشابه
ADC testing using digital stimuli
The Analogue-to-Digital Converter (ADC) is one of the most typical and widely used mixed-signal circuits. They are applied in video, audio, high-speed communications systems and so on. Many ADCs are integrated into platform-based designs, the architecture which normally contains of standard blocks such as memories, digital processors, RF and analogue front-ends. As testing such a system is a co...
متن کاملAdc Architectural Diagnostic Testing Procedures
Fred H. Irons, Donald M. Hummels, and Cindy ????? Zoldi Department of Electrical and Computer Engineering University of Maine, Orono, Maine USA [email protected] ABSTRACT Procedures have been developed to apply ADC modeling techniques to the diagnosis of high-speed Folding Amplier Interpolating Resistive (FAIR) networks. This paper presents results and describes procedures used to obtain mea...
متن کاملNoise floor in ADC testing
Noise floor is a frequency spectrum parameter that is widely used in ADC testing although it has not been properly defined and described by a formula in any ADC standards yet. IEEE Std 1057-1994 does not mention the noise floor but it generally uses noise or noise level that is not defined. IEEE Std 12412000 provides a formula for noise floor computation depending on the number of ADC bits; con...
متن کاملSignal Generator with Minimal Distortion for ADC Testing
The special generator of testing signal was designed for the frequency of 441.171 kHz. The generator consists of the special crystal oscillator and a high power amplifier. The frequency stability of the generator is in order of 10/day, the output power 1W, the value of SINAD is close to 120 dB and the total harmonic distortion under 170 dB by using of linear narrow-band filter.
متن کاملConcurrent Testing of ADC for Embedded System
Compaction testing methods allow at-speed detecting of errors while possessing low cost of implementation. Owing to this distinctive feature, compaction methods have been widely used for built-in testing, as well as external testing. In the latter case, the bandwidth requirements to the automated test equipment employed are relaxed which reduces the overall cost of testing. Concurrent compactio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Instrumentation and Measurement
سال: 2008
ISSN: 0018-9456,1557-9662
DOI: 10.1109/tim.2008.928404