Adhesion state estimation based on improved tire brush model
نویسندگان
چکیده
منابع مشابه
mortality forecasting based on lee-carter model
over the past decades a number of approaches have been applied for forecasting mortality. in 1992, a new method for long-run forecast of the level and age pattern of mortality was published by lee and carter. this method was welcomed by many authors so it was extended through a wider class of generalized, parametric and nonlinear model. this model represents one of the most influential recent d...
15 صفحه اولEstimation of Tire-Road Friction by Tire Rotational Vibration Model
Tire-road friction is the most important piece of information used by active safety systems. However, most conventional friction estimation/ detection methods are accurate only within the non-linear region. In addition, such methods require numerous sensors, such as yaw rate sensors, acceleration sensors, and steering angle sensors. In this paper, a friction estimation method using a tire vibra...
متن کاملGeometric design safety estimation based on tire–road side friction
A closed-loop drive–vehicle–road–environment system (DVRES) model was established using Adams/Car and Matlab/Simulink. Dynamic responses of lateral tire forces based on tire–road side friction and road geometric characteristics are used to investigate vehicle side slip for geometric design safety estimation. The root mean square, the maximum values of lateral tire forces, comfort limit on curve...
متن کاملSlip-based Estimation of Tire|road Friction
An approach to estimate the tire{road friction during normal drive using only the wheel slip, that is, the relative diierence in wheel velocities, is presented. The driver can be informed about the maximal friction force and be alarmed for sudden changes. Friction related parameters are estimated using only signals from standard sensors in a modern car, and the physical relation between these p...
متن کاملSlip-based tire-road friction estimation
Tire-road friction is estimated using the wheel-slip computed from standard sensor signals. A parametric model is estimated using an adaptive lter supported by a fault detector. Results from extensive eld trials are presented. An approach to estimate the tire{road friction during normal drive using only the wheel slip, that is, the relative diierence in wheel velocities, is presented. The drive...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Mechanical Engineering
سال: 2018
ISSN: 1687-8140,1687-8140
DOI: 10.1177/1687814017747706