Air Cooling of Mini-Channel Heat Sink in Electronic Devices
نویسندگان
چکیده
منابع مشابه
Analysis of two!layered micro!channel heat sink concept in electronic cooling
In this work\ a new concept for a two!layered micro!channel heat sink with counter current ~ow arrangement for cooling of the electronic components is proposed[ The thermal performance and the temperature distribution for these types of micro channels were analyzed and a procedure for optimizing the geometrical design parameters is presented[ While the power supply system of the two!layered des...
متن کاملTwo-Phase Electronic Cooling Using Mini-Channel and Micro- Channel Heat Sinks: Part 1 — Design Criteria and Heat Diffusion Constraints
Mini-channel (D = 2.54 mm) and micro-channel (D = 510 pm) heat sinks with a 1-cm heated surface were tested for their high heat flux performance with flow boiling ofR-113. Experimental results yielded CHF values in excess of 200 W cm~ for flow rates less than 95 ml min~ (0.025 gpm) over a range of inlet subcooling from 10 to 32° C. Heat diffusion within the heat sink was analyzed to ascertain t...
متن کاملExperimental Study of Single Phase Flow in a Closed-Loop Cooling System with Integrated Mini-Channel Heat Sink
The flow and heat transfer characteristics of a closed-loop cooling system with a mini-channel heat sink for thermal management of electronics is studied experimentally. The heat sink is designed with corrugated fins to improve its heat dissipation capability. The experiments are performed using variable coolant volumetric flow rates and input heating powers. The experimental results show a hig...
متن کاملTwo-Phase Electronic Cooling Using Mini-Channel and Micro-Channel Heat Sinks: Part 2—Flow Rate and Pressure Drop Constraints
Increased rate of heat dissipation from electronic chips was explored by the application of flow boiling in mini-channel (D = 2.54 mm) and micro-channel (D — 510 \x,m) heat sinks with special emphasis on reducing pressure drop and coolant flow rate. A pressure drop model was developed that accounts for the single-phase inlet region, the singleand two-phase heated region, and the two-phase unhea...
متن کاملTwo-phase flow in high-heat-flux micro-channel heat sink for refrigeration cooling applications: Part II—heat transfer characteristics
This paper is the second of a two-part study concerning two-phase flow and heat transfer characteristics of R134a in a micro-channel heat sink incorporated as an evaporator in a refrigeration cycle. Boiling heat transfer coefficients were measured by controlling heat flux (q00 = 15.9 93.8W/cm) and vapor quality (xe = 0.26 0.87) over a broad range of mass velocity. While prior studies point to e...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Electronics Cooling and Thermal Control
سال: 2013
ISSN: 2162-6162,2162-6170
DOI: 10.4236/jectc.2013.32007