Aircraft Cable Fault Detection and Location Based on SSTDR
نویسندگان
چکیده
منابع مشابه
Immunity-Based Aircraft Fault Detection System
In the study reported in this paper, we have developed and applied an Artificial Immune System (AIS) algorithm for aircraft fault detection, as an extension to a previous work on intelligent flight control (IFC). Though the prior studies had established the benefits of IFC, one area of weakness that needed to be strengthened was the control dead band induced by commanding a failed surface. Sinc...
متن کاملControl-based fault detection and isolation for autonomous aircraft
This paper describes a new method to perform fault detection and isolation for a closedloop-controlled autonomous aircraft. This vehicle is equipped with standard sensors and actuators, and its dynamics is nonlinear. It is assumed that a guidance law and a control loop have been designed to achieve a given mission. The diagnosis method uses the resulting control objectives to generate residuals...
متن کاملAircraft Electrical Monitoring & Fault Detection
Fault detection and electrical system monitoring (management) for aircraft/spacecraft dc or 400 Hz electrical systems is presented. Real-time ‘snapshot’ data is collected from current and voltage measurement transducers on radial or loop aircraft electrical system and introduced into a State Estimator. The State Estimator ‘smoothes’ the data, detects bad transducers, and calculates the best est...
متن کاملInternal Fault Detection, Location, and Classification in Stator Winding of the Synchronous Generators Based on the Terminal Voltage Waveform
In this paper, a novel method is presented for detection and classification of the faultyphase/region in the stator winding of synchronous generators on the basis of the resulting harmoniccomponents that appear in the terminal voltage waveforms. Analytical results obtained through DecisionTree (DT) show that the internal faults are not only detectable but also they can be classified andthe rela...
متن کاملArcing Fault Detection and Fault Location on Hv Transmission Lines
In this paper a new numerical algorithm for fault distance calculation and arcing fault recognition, based on one terminal data and derived in the time domain, is presented. The algorithm is derived for the case of most frequent single-phase line to ground fault. The faulted phase voltage is modelled as a serial connection of the fault resistance and the arc voltage. The fault distance and the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: DEStech Transactions on Computer Science and Engineering
سال: 2019
ISSN: 2475-8841
DOI: 10.12783/dtcse/aicae2019/31492