AL 6082 AND AL 7075 ALLOYS UNDER THE MODIFIED LOW-CYCLE FATIGUE TEST
نویسندگان
چکیده
منابع مشابه
THERMAL FATIGUE RESISTANCES OF 356 AND 413 CAST Al ALLOYS
Abstract: Thermal fatigue is a stochastic process often showing considerable scatter even in controlled environments. Due to complexity of thermal fatigue, there is no a complete analytical solution for predicting the effect of this property on the life of various components, subjected to severe thermal fluctuations. Among these components, one can mention car cylinder, cylinder head and pi...
متن کاملFatigue Behaviour of Al 6082-T6 Friction Stir Welded Tubular Joints under Torsional Loading
The aim of the present research is to investigate the fatigue behaviour of friction stir (FS) welded tubular joints in aluminium alloy subjected to torsional fatigue loading. To manufacture the samples which were tested, an MTS I-STIR process development system was equipped with a retracting tool specifically designed for these tubular welds. Al 6082-T6 FS welded samples were tested under cycli...
متن کاملInfluence of Heat Treatment on the Surface Structure of 6082 Al Alloys
The b-Al5FeSi intermetallic phase and coarse Mg2Si particles have negative effects on extrudability and workability of 6xxx Al alloys billets. To achieve extruded products with a high surface quality, the as-cast billets are heat-treated before extrusion. During heat treatment, the undesired intermetallic particles, i.e., b-AlFeSi platelets are transformed to rounded a-Al(FeMn)Si intermetallic ...
متن کاملStudy of the Mechanism and Causes of Pore Formation in Sr-modified Al-Si Alloys
The formation of microporosity in modified Al-Si alloys has been reviewed in the present study. A major concern in modification is the increased tendency to form microporosity in the macro-shrinkage free Al-Si alloy castings. It has also been demonstrated that at low hydrogen contents (0.1cc/ 100g, Al), where only shrinkage porosity should occur, the effect of Sr-modification on porosity conten...
متن کاملStudy of the Mechanism and Causes of Pore Formation in Sr-modified Al-Si Alloys
The formation of microporosity in modified Al-Si alloys has been reviewed in the present study. A major concern in modification is the increased tendency to form microporosity in the macro-shrinkage free Al-Si alloy castings. It has also been demonstrated that at low hydrogen contents (0.1cc/ 100g, Al), where only shrinkage porosity should occur, the effect of Sr-modification on porosity conten...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metallurgy and Foundry Engineering
سال: 2016
ISSN: 1230-2325
DOI: 10.7494/mafe.2016.42.1.57