All-Optical Triode Based on Negative Feedback Semiconductor Optical Amplifi ers Using Fiber Bragg Gratings
نویسندگان
چکیده
منابع مشابه
Negative Feedback Semiconductor Optical Amplifiers and All-Optical Triode
The field of optical communications is moving toward the realization of photonic networks with wavelength division multiplexing (WDM) utilizing the full bandwidth of optical fibers. Conventionally, an erbium-doped fiber amplifier (EDFA) and a semiconductor optical amplifier (SOA) are used for amplifying an optical signal in optical communications. SOAs can contribute to this and offer the key a...
متن کاملTunable all-optical negative multitap microwave filters based on uniform fiber Bragg gratings.
We present a novel and simple technique for obtaining transversal filters with negative coefficients by using uniform fiber Bragg gratings. We demonstrate a wide tuning range, good performance, low cost, and easy implementation of multitap filters in an all-optical passive configuration in which negative taps are obtained by use of the transmission of a broadband source through uniform Bragg gr...
متن کاملMulticasting Characteristics of All-Optical Triode based on Negative Feedback Optical Amplifiers
We introduce all-optical multicasting characteristics with wavelength conversion based on all-optical triode using two full bands tunable distributed-feedbacklaser diode module at a transfer speed of 10 Gbps to a non-return-zero 231-1 pseudorandom bit sequence system. This multi-wavelength converter device can simultaneously provide two channels of output signal with the support of non-inverted...
متن کاملAll-optical fiber anemometer based on laser heated fiber Bragg gratings.
A fiber-optic anemometer based on fiber Bragg gratings (FBGs) is presented. A short section of cobalt-doped fiber was utilized to make a fiber-based "hot wire" for wind speed measurement. Fiber Bragg gratings (FBGs) were fabricated in the cobalt-doped fiber using 193 nm laser pulses to serve as localized temperature sensors. A miniature all-optical fiber anemometer is constructed by using two F...
متن کاملBulk regeneration of optical fiber Bragg gratings.
The reliability and reproducibility of regenerated gratings for mass production is assessed through simultaneous bulk regeneration of 10 gratings. The gratings are characterized and variations are compared after each stage of fabrication, including seed (room-temperature UV fabrication), regeneration (annealing at 850°C), and postannealing (annealing at 1100°C). In terms of Bragg wavelength (λ(...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Review of Laser Engineering
سال: 2009
ISSN: 0387-0200,1349-6603
DOI: 10.2184/lsj.37.540