Alloy Design of 5%Mn-Cr-C System Austenitic Steel
نویسندگان
چکیده
منابع مشابه
Optimization of Weld Bead Width in Tungsten Inert Gas Welding of Austenitic Stainless Steel Alloy
This paper investigates the effects of process parameters on weld bead width of austenitic stainless steel SS-310 in tungsten inert gas welding. The four parameters namely welding current, type of gas, gas flow rate and included angle of weld plates during butt joint were varied at three levels. The DOE approach was used to design experimental conditions. Orthogonal array L9 was used for carryi...
متن کاملDissimilar laser welding of NiTi shape memory alloy to austenitic stainless steel archwires
In this research, dissimilar welding of NiTi shape memory alloy to AISI 304 austenitic stainless steel Archwires was investigated. For this purpose, common straight orthodontic archwire with rectangular cross-section and dimensions of (0.635 × 0.432 mm) were selected and the laser welding technique was used to connect the wires. The microstructure, chemical composition and phasesin the weld zon...
متن کاملDissimilar laser welding of NiTi shape memory alloy to austenitic stainless steel archwires
In this research, dissimilar welding of NiTi shape memory alloy to AISI 304 austenitic stainless steel Archwires was investigated. For this purpose, common straight orthodontic archwire with rectangular cross-section and dimensions of (0.635 × 0.432 mm) were selected and the laser welding technique was used to connect the wires. The microstructure, chemical composition and phasesin the weld zon...
متن کاملUltrafine-Grained Structure of Fe-Ni-C Austenitic Alloy Formed by Phase Hardening
The X-ray and magnetometry methods were used to study α-γ transformation mechanisms on heating quenched Fe-22.7 wt.% Ni-0.58 wt.% С alloy. Variation of heating rate within 0.03-80 K/min allowed one to switch from diffusive to non-diffusive mechanism of the α-γ transformation. Heating up primary austenitic single crystal specimen at a rate of less than 1.0-0.5 K/min has led to formation of aggre...
متن کاملDesign optimization of cutting parameters for turning of AISI 304 austenitic stainless steel using Taguchi method
In the present work Taguchi method is used to optimize cutting parameters during dry turning of AISI 304 austenitic stainless steel with AlTiCrN coated tool. The coating was deposited on fine-grained K-grade (ISO K-20) cemented carbide cutting insert using physical vapor deposition (PVD) technique. The turning parameters evaluated are cutting speed of 200 and 260 m/min, feed rate of 0.20 and 0....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 2013
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane.99.509