Alloy Electroplated Steel Sheet.
نویسندگان
چکیده
منابع مشابه
Numerical and Experimental Investigations on Springback of U-bending of DP600 Steel Alloy Sheet
The most prominent feature of sheet material forming process is an elastic recovery phenomenon during unloading which leads to springback and side wall curl. Therefore evaluation of springback and side wall curl is mandatory for production of precise products. In this paper, the effects of some parameters such as friction coefficient, sheet thickness, yield strength of sheet and blank-holder fo...
متن کاملHydrogen Embrittlement of High Strength Steel Electroplated with Zinc-cobalt Alloys
Slow strain rate tests were performed on quenched and tempered AISI 4340 steel to measure the extent of hydrogen embrittlement caused by electroplating with zinc-cobalt alloys. The effects of bath composition and pH were studied and compared with results for electrodeposited cadmium and zinc-10%nickel. It was found that Zinc-1%cobalt alloy coatings caused serious hydrogen embrittlement (EI 0.63...
متن کاملNanopipette-Based Electroplated Nanoelectrodes.
Here, we report a nanopipette-based electrochemical approach to prepare metal nanoelectrodes with excellent control over electrode size, shape, and thickness of the insulation wall. Nanoelectrodes are prepared by electrochemical plating in a laser-pulled quartz nanopipette tip immersed in a liquid gallium/indium alloy electrode, which not only protects the ultrasmall quartz tip but also starts ...
متن کاملElectrochemical Effects in Electroplated
Hybrid microcircuit packages are multicomponent electronics devices used in high tech military equipment. They also find application in medical devices for implant in humans to abort the attack of many life threatening illnesses. These are electroplated with limited thicknesses of nickel (1.25 8.75pm) and gold (1.25 5.6pm). In addition there are post plate baking and steam aging requirements as...
متن کاملFretting wear in self-piercing riveted aluminium alloy sheet
Fretting wear in aluminium alloy AA5754 joined by self-pierce riveting (SPR), a relatively new fastening technique increasingly used in vehicle structures, has been investigated in this paper. Surface damages have been induced when a joint experienced a sinusoidal cyclic tension-tension load. Various degradation zones have been characterised in the contact surfaces between the aluminium sheets,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Surface Finishing Society of Japan
سال: 1995
ISSN: 0915-1869,1884-3409
DOI: 10.4139/sfj.46.24