Aluminium Foil and Cold Spray Copper Technology as Cost Reduction Process Step in Back-contact Module Design
نویسندگان
چکیده
منابع مشابه
Simple, low cost MHz-order acoustomicrofluidics using aluminium foil electrodes.
It is now possible to circumvent costly and complex cleanroom fabrication procedures to produce MHz-order acoustically-driven microfluidic platforms through the use of electrode strips cut simply from kitchen aluminium foil and pressed against piezoelectric substrates. Cleanroom deposition, lithographic patterning, and etching are entirely avoided in favor of this cut-and-place technique, which...
متن کاملRelation of Contact Resistance Reduction and Process Parameters of Bonded Copper Interconnects in Three-dimensional Integration Technology
Contact resistances of bonded copper interconnects in threedimensional integration technology under different bonding conditions are investigated by using a novel test structure. A reduction in specific contact resistance is obtained by longer anneal time. The specific contact resistance of bonded interconnects with longer anneal time does not change with the interconnect sizes. Underlying phys...
متن کاملEffect of Back-contact Copper Concentration
CdTe solar cells were fabricated with five different concentrations of copper, including zero, used in backcontact formation. Room-temperature J-V curves showed progressive deterioration in fill factor with reduced copper. JSC and QE were similar for all Cu-levels. Capacitance measurement suggested enhanced intermixing at the back contact with copper present. Photocurrent mapping was much less ...
متن کاملElectron Rutherford back-scattering case study: oxidation and ion implantation of aluminium foil
Electron Rutherford back scattering (ERBS) is a new spectroscopy for determining the composition of surfaces. In this work the surface sensitivity of ERBS was investigated by changing the entrance and exit angle of the electron beam while keeping the scattering angle constant. It was found that in this way the surface sensitivity of the technique can be varied considerably. We use aluminium as ...
متن کاملCorrosion of Cold Spray Deposited Copper Coating on Steel Substrates
The corrosion behavior of copper cold spray coatings on a carbon steel substrate was compared to that of commercially available wrought copper under the conditions anticipated in a nuclear waste repository. Corrosion potential and linear polarization resistance measurements were conducted over 90 d to 120 d in 3.0 mol/L NaCl under anoxic (1) and oxygenated-toanoxic (2) conditions to simulate th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Energy Procedia
سال: 2014
ISSN: 1876-6102
DOI: 10.1016/j.egypro.2014.08.099